Parts for Ge TAX6SISAWH: 01 - Section1 Parts

8 - 18 x .375

The R134 Drier is an OEM part for GE refrigerators. This component plays a critical role in the refrigeration system by removing moisture and contaminants from the refrigerant, ensuring efficient cooling and preventing damage to other parts of the system. It helps maintain the purity and effectiveness of the refrigerant as it cycles through the system.

You should replace the R134 drier if it becomes clogged or damaged. Common causes of a bad drier include wear and tear over time, exposure to moisture, or contamination from other failing components in the refrigeration system.

Symptoms of a bad R134 drier include:

• Reduced cooling efficiency
• Frost buildup on the evaporator coils
• Unusual noises from the refrigeration system
• Increased energy consumption
• Refrigerator not maintaining the set temperature

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This cover relay is a protective plastic housing that shields the appliance's relay/switch area, helping prevent accidental contact and debris from affecting electrical relay components. It keeps relay parts covered for safer operation and service access. What it does:

• Shields relay contacts and wiring from dust, grease, and physical contact
• Helps reduce risk of accidental shocks when accessing control area
• Supports proper component alignment and secures the relay assembly in place
• Common symptom: relay area exposed, loose cover, or visible wear around relay housing

• One cover relay housing (single piece)

• Disconnect power to the appliance before starting any service
• Remove screws or mounting clips securing the old cover; handle surrounding wiring gently
• The replacement aligns with relay mounting tabs and fasteners before tightening
• If any relay components are damaged or sparking, replace the relay.

This molded J-shaped drain elbow channels defrost and condensation water from the evaporator area to the refrigerator drain system, helping prevent pooling and water leaks inside the fresh food compartment. What it does

• Directs defrost/condensation water into the drain system to prevent standing water under the evaporator.
• Guides flow from the evaporator cover or drain trough to the main drain tube or pan.
• Common symptoms of a failing J-trap: water pooling inside the refrigerator, leaks at the front lower area, or slow drainage from the evaporator area.

• One J-trap drain elbow.

• Disconnect power before servicing and allow the evaporator area to thaw if iced.
• Remove applicable interior panels or evaporator cover to access the drain path.
• Inspect mating seals and surrounding drain tubing; replace if cracked or degraded to ensure a tight fit.
• Reassemble panels and restore power; run a short defrost or pour small amount of water to confirm proper drainage.