Parts for Ge GUD27EESN0WW: Dryer Cabinet Parts

A replacement silicon controlled rectifier (SCR) that restores proper high-current switching for heating or ignition circuits. Replacing a failed SCR helps stop intermittent heating, loss of element power, or erratic control behavior. What it does:

• Switches and regulates high-current power flow to heating, ignition or motor circuits when gated by the appliance control.
• Prevents or causes intermittent/no-heat conditions when failing or shorted.
• Stops erratic cycling or loss of controlled power to the affected circuit.
• Operates as a direct electrical replacement for the factory SCR specified by the appliance manufacturer.

• Disconnect power before servicing; this part is used in high-voltage sections.
• Match part number and orientation exactly; some installations require soldering or secure connector seating.
• Discharge capacitors and observe ESD precautions when handling electronic components.

A push-on speed nut that secures panels, trim, or lightweight components to studs and shafts, restoring a tight, rattle-free fit. Ideal when the original retaining nut is damaged or missing. What it does

• Climbs and locks onto a threaded stud or shaft to hold panels and assemblies in place
• Prevents loosening and vibration that can cause rattles or misalignment
• Common replacement when the original nut is stripped, cracked, or no longer grips

• Disconnect power and water (if applicable) before servicing the appliance
• Press the nut firmly onto the stud or shaft until fully seated; use pliers for tight fits if needed
• Replace any damaged mating hardware for a secure repair

This is a #8-18 by 5/8-inch Torq II-head screw used to secure appliance panels and components. It provides a reliable fastener option when replacing stripped or missing screws to restore proper fit and reduce vibration or rattling. What it does:

• Secures trim, panels, brackets or small components to appliance frames
• Restores proper alignment and reduces noise from loose parts
• Replaces worn, stripped, or missing fasteners to prevent further damage
• Compatible where an 8-18 thread and 5/8" length with a Torq II-style head are specified

• One screw

• Use the correct Torq II driver bit to avoid cam-out or head damage
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic
• If replacing rusted or stripped screws, inspect mating threads and replace as needed
• Disconnect power and follow appliance safety instructions before servicing

Size: 8-32 t. Includes 12 screws.

Size: 8 - 18 ab.