Parts for Ge UCG1510N0II: Frame Parts

Fix a compactor that won't stop at the top or hums but won't move. This directional limit switch controls ram travel. DIY repair in under 30 minutes.

If your trash compactor won't turn on or power is intermittent, this main console power switch restores reliable on/off control. Direct fix for dead units.

M3 x 25mm hex head flange bolt secures panels, brackets, and components in trash compactors. Replace worn, missing, or stripped mounting bolts.

This back panel replaces the dryer's rear housing cover to protect internal components and help keep lint and debris out of service areas. Restores the cabinet's structural finish and access for service. What it does:

• Covers and protects the dryer's internal components at the rear
• Helps prevent lint, dust, and foreign objects from entering service areas
• Restores a secure mounting surface for controls, vents, and rear-mounted components
• Supports proper cabinet alignment and finish for safe operation

• 1 back panel / rear housing

• Disconnect power (and gas, if applicable) before attempting replacement
• Use appropriate hand tools; avoid over-tightening fasteners to prevent cracking
• Keep lint and debris cleared from the area before reassembly

Frame roller assembly mounts to the compactor frame to support the sliding drawer. Replace if the roller is worn, cracked, or causing sticking movement.

Protects drawer slide mechanism from debris and grease buildup. Replace if cracked, missing, or drawer movement becomes rough. Confirm fit with your model number.

Compactor won't start or lights stay on? This door tilt switch detects open/closed position to control cycles. Easy DIY fix in under 30 minutes.