Parts for Kitchenaid KRBL109ESS02: Freezer Door Parts

This is a stainless-steel refrigerator door designed to restore appearance and sealing function to compatible units. It replaces a damaged or dented outer door to help keep contents insulated and the appliance looking like new. What it does:

• Replaces a damaged, dented, or corroded outer refrigerator door panel
• Restores proper sealing and alignment that can reduce cold air loss
• Returns original finished appearance for a stainless-steel front
• Helps eliminate rattling or sticking caused by a warped door

• Installation may require removing interior trim, hinge pins, and disconnecting door-mounted components; have appropriate hand tools ready
• Support the door during removal/installation to avoid dropping or scratching the finish
• Inspect and reuse or replace existing gaskets, hinges, and fasteners as needed
• Disconnect power to the appliance before servicing if the door contains electrical components

The Freezer Door Gasket is an OEM part for Whirlpool refrigerators. It forms an air tight perimeter around the freezer door opening to prevent moisture and air seepage into frozen items.

Causes of failure can include cracking or separation of the adhesive backing from the door flange over repeated use. General deterioration is also common from exposure to temperature extremes.

Symptoms of a defective freezer door gasket include:

• Frost or condensation build up inside the freezer
• Higher energy bills from lost insulation
• Inability to maintain below freezing temperatures
• Faster ice cube melting or frost patterns on packages

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This replacement screw fastens appliance panels and components securely. Replace a missing, stripped, or corroded original to restore a tight fit and help prevent rattling, vibration, and gradual loosening of assemblies.

• Secures panels, brackets, and internal assemblies to the frame
• Replaces damaged or missing hardware to maintain proper fit
• Helps reduce vibration, noise, and movement caused by loose parts
• Supports correct alignment at the original mounting points

• Disconnect power and shut off water or gas before service.
• Match the original screw's location and length; replace one at a time if needed.
• Use the correct driver/bit and avoid overtightening to prevent stripping plastic or metal.
• Reuse any washers or clips only if in good condition.