Parts for Ge GTE18LMHLRES: Fresh Food Section Parts

Dishwasher nozzle and foam gasket seals spray arm connection. Replace if leaking, worn, or spray performance declines. Verify fit with your model number.

Refrigerator not cooling or ice building up on evaporator coils? The defrost timer controls the defrost cycle. DIY-friendly, installs in 5 minutes.

Leveling leg threads into the refrigerator base to support and stabilize the cabinet. Replace if cracked, broken, or worn to keep your unit level.

Supports and pivots your refrigerator door for smooth opening and closing. Replace when door sags, misaligns, or won't seal properly. Confirm fit with your model number before ordering.

Replace your refrigerator's center door hinge to restore smooth door movement and maintain a proper seal. Supports door weight at the pivot point. Confirm fit with your model number before ordering.

Pivot shaft for refrigerator doors at the middle hinge. Replace if worn or bent to restore proper door alignment and smooth operation. Verify fit.

This small replacement corner cap covers and protects an appliance's outer corner trim, restoring a finished look and keeping edges from catching or chipping. It's a simple cosmetic and protective part for worn or broken corner trim. What it does:

• Covers and protects the outer corner of the appliance trim to prevent catches and chips
• Restores a clean, finished appearance where original corner caps are cracked or missing
• Helps keep trim edges aligned and reduces risk of sharp exposed edges
• Common remedy for visible damage after bumps, drops, or long-term wear

• Disconnect power to the appliance before attempting any service that requires removing trim or glass.
• Handle trim and glass carefully—wear gloves and eye protection to avoid cuts from sharp edges.
• This cap typically snaps or fits into place or secures with existing trim hardware; your model's service instructions for removal and reinstallation details.
• If the original trim or mounting clips are damaged, replacement of those items may be required for a secure fit.

Small washer that fits on refrigerator door hinges to distribute weight and reduce friction. Replace if worn, cracked, or missing to restore proper alignment.

Supports the refrigerator door at the lower pivot point for smooth opening and proper sealing. Replace if the door sags or won't close tightly. Confirm fit by model number.

Bottom hinge pin secures the refrigerator door at the base, allowing smooth opening and closing. Replace if worn, damaged, missing, or door sags.

Right front wheel assembly for refrigerators. Installs on the bottom right corner for smooth rolling. Replace if cracked, broken, or missing.

Control knob fits onto your refrigerator's control shaft to adjust temperature and settings. Replace a cracked, stripped, or missing knob for smooth operation.

Fix inconsistent cooling or temperature fluctuations with this refrigerator temperature control sensor. Simple DIY repair that monitors interior conditions.

Foam gasket seals the water supply nozzle connection to prevent leaks and reduce vibration. Replace if worn or leaking. Confirm fit with your model number.

Vinyl sleeve that fits over rods, tubes, or wires in your refrigerator. Replace if cracked, torn, or missing to protect contact points and reduce wear.

Replace a cracked or broken control housing frame on your refrigerator. This console frame secures the control board and user interface components.

Refrigerator light not working or flickering? A faulty light socket often causes this. Simple plug-in repair with no tools required. Video guide available.

Fix interior lights that won't turn on, stay on constantly, or delay when opening the door. This switch replacement takes 10-15 minutes with basic tools.

Replacement mounting screw for refrigerator panels, brackets, and covers. Needed when original screw is missing, stripped, or damaged during service work.