General Electric Touch Pad

This is the panel control tape ribbon assembly used to connect the console touchpad to the oven control electronics, restoring reliable button and display communication for the appliance control panel. What it does:

• Transfers signals between the touchpad/console and the main control board so button presses register.
• Replaces damaged, cracked or worn ribbon contacts that cause intermittent or non-responsive controls.
• Helps resolve issues like unresponsive keys, error codes tied to keypad faults, or sporadic display behavior.
• Flexible ribbon design lets it fit behind the control panel without bulky wiring.

• One panel control tape ribbon assembly as shown.

• Disconnect power to the appliance (unplug or shut off breaker) before starting.
• Handle ribbon contacts carefully—avoid sharp bends, creases, or touching conductive traces.
• Installation typically requires removing the front control panel or console; keep screws and clips organized.

Color: Black

This keypad is the front control panel membrane that lets you select cycles and settings for the appliance. It restores tactile button response and reliable user input so the unit accepts commands again. What it does:

• Replaces a worn or damaged control-panel keypad so button presses register correctly
• Restores touch/press input used to select cycles, options, and start functions
• Can resolve symptoms like unresponsive or intermittent buttons and failure to accept selections
• Helps eliminate erratic control behavior caused by a cracked or delaminated keypad

• Disconnect power to the appliance before beginning any service
• Remove the control panel or console trim to access the keypad
• Handle the flexible ribbon cable and connector gently to avoid damage

This white backsplash assembly restores the finished rear appearance of a range and helps protect the wall from spills, splatters, and heat. It provides a clean, factory-fit rear cover for affected models. What it does:

• Covers and protects the rear wall area behind the range from grease, food splashes, and light heat exposure
• Restores the appliance's factory appearance when the original backsplash is damaged or missing
• Secures to the range frame to provide a finished mounting surface for rear components on applicable models
• Prevents debris from entering gaps between the appliance and wall

• Disconnect power (and gas, if applicable) before beginning service
• Remove screws or fasteners holding the old backsplash; save hardware for reassembly if reusable
• Handle edges carefully; use proper hand tools and follow the appliance wiring/part diagram

This HMI assembly is the user-interface control panel that lets you operate the appliance's front controls and display. Replaces a damaged or unresponsive control surface to restore button and display functionality. What it does:

• Provides the push-button controls and display interface for operating the appliance.
• Sends user commands to the main control board for functions like cycle selection, options, and start/stop.
• Commonly replaces units that are cracked, have unresponsive buttons, or show display errors.
• Helps resolve intermittent or failed front-panel communication when the HMI is the diagnosed fault.

• High-level replacement only; refer to factory service literature for step-by-step procedures.
• Disconnect power to the appliance before servicing to avoid shock or damage.
• Handle the assembly carefully to avoid damaging connectors, ribbon cables, or the display lens.

This electronic control unit replaces the oven/range control board to restore normal control and display functions. It provides the interface that manages cook cycles, timing, and user inputs for safe, reliable operation. What it does:

• Manages oven/range control logic, timers and display functions
• Responds to touchpad/knob commands and signals heating elements or igniters
• Helps stop erratic cycling, unresponsive controls or incorrect cook times
• Resolves blank or incorrect display, or loss of control panel responsiveness

• Disconnect power at the breaker or unplug the appliance before starting
• Handle the board carefully; avoid touching circuitry and use anti-static precautions
• Use basic hand tools to access the control panel; keep fasteners for reassembly