Parts for Kitchenaid KVUB406GSS02: Hood Parts

This hood damper mounts at the exhaust outlet to let cooking air exit while blocking backdrafts when the fan is off. Replacing a worn damper restores proper airflow and helps eliminate rattling or sticking during vent operation.

• Controls one-way airflow from the hood into the duct; seals when the fan is off
• Helps block outside air and moisture from entering through the vent
• Wear or damage can cause poor venting, rattling noises, or a stuck exterior flap
• Restores vent performance after the original damper is bent, warped, or missing

• Disconnect power at the breaker before servicing
• Access the exhaust outlet and remove the old damper; note airflow orientation
• Install so the flap swings freely and seats closed; avoid overtightening fasteners
• Run the fan to verify smooth damper movement and proper airflow

This run capacitor helps the appliance's motor start and run smoothly by providing a phase-shifted electrical boost. Replacing a worn capacitor restores reliable motor operation and can stop start-up problems and irregular running. What it does:

• Provides the motor with the extra electrical charge needed for starting and stable operation
• Commonly linked to symptoms like hard-starting, a loud humming motor, or motors that won't start
• Stabilizes motor speed and reduces stress on the motor and start components
• Works as a direct replacement for the original capacitor specified for the motor circuit

• Disconnect power to the appliance before servicing to avoid shock hazard
• Discharge the capacitor before touching terminals; capacitors can hold a charge after power is removed
• Use insulated tools and avoid bridging terminals during handling

This fan motor is the rotating blower assembly that moves air through the appliance to support cooling, ventilation and proper operation. Replacing a worn motor restores airflow and helps maintain temperature control and performance. What it does:

• Drives the blower wheel to circulate air through the appliance cabinet and vents
• Restores airflow when the motor has failed or stalled
• Stops or reduces abnormal noise when the original motor bearings are worn
• Helps prevent overheating by maintaining proper ventilation

• Disconnect power before attempting any service to avoid shock or injury
• Handle the motor and blower wheel carefully to avoid damaging blades or connectors
• Verify wiring connections and mounting orientation match the original part before powering on

This insulation panel helps reduce noise and helps maintain proper cabinet temperature by adding thermal and acoustic protection inside the appliance. It restores quieter operation and improved temperature stability when the original pad is damaged or missing. What it does:

• Provides thermal barrier to help stabilize internal temperatures and reduce heat transfer
• Dampens vibration and reduces operational noise for quieter performance
• Helps limit condensation and drafts around the cabinet area
• Restores proper fit and coverage when the original insulation is torn, compressed, or missing

• Disconnect power to the appliance before starting any repair
• Handle with gloves and eye protection — insulation material can irritate skin and lungs
• Avoid compressing or folding the insulation when installing; maintain original shape for best performance
• Reinstall any clips or adhesive strips removed during disassembly; replace fasteners if damaged

This microwave charcoal filter captures cooking odors and smoke in recirculating setups to help keep air moving cleanly through the blower. Replace a saturated or damaged filter to maintain ventilation performance and minimize lingering smells.

• Adsorbs odors and smoke during non-vented operation
• Helps maintain airflow and keep internal surfaces cleaner
• Common signs it's due: persistent odors, reduced airflow, or a visibly dirty/damaged filter
• Intended for over-the-range microwaves that use a charcoal air filter

• Disconnect power to the microwave before servicing
• Remove the upper grille or access panel per your model; release and remove the old filter
• Install the new filter in the same orientation; reinstall grille and restore power