Parts for Goldstar MV1610ST: Installation Parts

This mounting plate is a metal bracket used to secure the microwave chassis/components in the correct position. A worn or damaged plate can cause poor fitment, vibration, or noise during operation.

• Provides a stable mounting surface for the designated microwave assembly
• Helps reduce vibration and rattling noises
• Restores proper alignment if the original plate is bent or broken
• Commonly replaced when the original plate is damaged or missing

• Unplug the appliance and discharge the high-voltage capacitor before servicing a microwave
• Use proper personal protective equipment; metal edges can be sharp
• Note orientation and fastener locations before removal
• Tighten mounting hardware evenly to avoid distortion

The Damper Bracket is an OEM component for LG microwaves. Located inside the microwave cavity above the wave stirrer, this bracket holds the position of the damper assembly that helps distribute heat evenly during cooking. The bracket measures approximately 12” by 5”.

Symptoms of a bad damper bracket can include:  

• Hot or cold spots developing within the microwave cavity
• Looseness in the damper assembly fit
• Reduced heat circulation leading to uneven cooking

Causes typically consist of cracking over long-term heat exposure. Repeated opening/closing of the damper may also weaken attachment points on the bracket.

This OEM LG part is also compatible with Sears/Kenmore microwaves. 

The Damper is an OEM component for LG microwaves. Located within the cooking cavity, it regulates airflow and safely vents steam escaping heated foods. 

Causes of a faulty damper can involve standard wear and exposure accepting steam and condensation release. Food or liquid particles drying within tracks also threaten eventual adhesion issues restricting travel if left unaddressed between cleanings.

Symptoms of a damaged or defective damper include:

• Inability to adequately vent excess moisture from heating  
• Potential messes spilling beyond the microwave frame  
• Grating sounds or squeaks emitting during cooking
• Flaps possibly stuck inhibiting steam circulation 

This damper is also compatible with Kenmore microwaves as well.

This replacement box label is the small identification sticker used on LG appliance packaging to display manufacturing and serial information—keeps product ID and barcode visible for service and shipping. What it does:

• Replaces a torn, faded, or missing identification sticker on the appliance box or component housing
• Restores legible serial, model or barcode information needed for service, shipment, or inventory
• Stops further peeling or loss of printed information when adhered to a clean surface
• Helps technicians and carriers quickly identify the unit during repair or transport

• Clean and dry the mounting surface before applying for best adhesion
• Align carefully; most labels are adhesive-backed and are not intended for repeated repositioning
• Dispose of old or damaged labels per local recycling guidelines
• No electrical tools or parts removal required for application

The Door Latch Housing and Interlock Switch Assembly is an OEM replacement part for LG microwaves. It consists of the protective door latch housing casing along with the two-door switches and interlock switch.

The interlock switch prevents microwave energy from being generated inside the oven when the door is open. It shuts off all power once a faulty seal is detected between the door and cavity.

Symptoms of issues can include:

• Microwave failing to turn on or cook with the door open
• Sparking or arcing seen near the door seal or frame
• Error codes displayed related to interlock detection faults

Compatible models include some GE, Kenmore, and Samsung units using matching door designs sourced from LG.