Parts for Whirlpool WGTLV27HW3: Optional Parts

A replacement mounting bracket that secures internal panels and components to the appliance frame, restoring proper alignment and support. Durable metal construction helps prevent rattling and misalignment caused by a damaged or missing bracket. What it does:

• Secures panels, assemblies, or controls to the appliance frame to maintain correct positioning
• Restores solid attachment that can stop rattling, vibration noise, or loose-fitting parts
• Prevents further wear on attached components by keeping them properly supported
• Matches OEM fit and mounting points for a direct replacement when the original bracket is bent or broken

• Disconnect power (and water, if applicable) before attempting any repair
• Use basic hand tools; support panels while removing fasteners to avoid dropping or damaging other parts
• Replace only the damaged bracket; inspect adjacent fasteners and mounts for wear

Fix leaks at your washer's inlet connection with this hose adapter. Provides a secure fit between your machine and water supply on export models.

Extends your dryer's exhaust duct to reach distant venting points. Replace if your current extension is crushed, kinked, or too short for proper routing.

Fix leaking water connections or add steam functionality with this Y-connector hose. Splits one inlet into two outlets for proper water routing.

Standpipe adapter for washer drain hose connection. Converts 1.5-inch to 2-inch standpipe sizes. Replace if cracked, broken, or missing for proper fit.

Gray acrylic spray paint for coating worn or chipped dryer drum interiors. Restores the protective finish when the original coating is scratched or flaking.

Test kit for checking dryer vent airflow performance. Includes tests for both top-mounted and front-mounted lint screen configurations with instructions.

Connects washer drain hose to extension hose. Includes coupling and clamps. Replace if cracked, broken, or when extending drain hose length to reach pipe.

Rubber washer gasket for washer fill hose connections. Replace if worn or leaking at coupler adapter. Measures 1-1/16 x 5/8 inch. Verify fit with model.

Extends your washer drain hose by 4 feet when the original is too short to reach your drain pipe. Connects to existing hose with clamp adapter kit.

Extends your washer's drain hose to reach distant standpipes or sinks. Includes coupler and clamps. Replace when you need extra length for installation.

Rubber inlet hose that connects your washer to the water supply. Replace if cracked, leaking, or worn. Standard 5-foot length with included washers.

Filters debris from water entering your washer and seals the hose connection. Replace if water fills slowly or screens are clogged. Confirm fit by model.