Parts for Ge CSB913M2N1S5: Oven Cavity Parts

Mica cover that protects the waveguide opening inside your microwave. Replace if cracked, burned, torn, or tabs have broken off during normal use.

Support bracket that secures internal components and keeps assemblies aligned in microwaves. Replace if cracked, broken, or missing to restore fit.

This adhesive foam seal tape provides a slim, flexible sealing strip used to restore a tight seal around appliance openings. It helps reduce air leaks, moisture intrusion and improves temperature stability for refrigerators and freezers. What it does:

• Creates a compressible, airtight seal where original foam tape has worn or separated
• Helps reduce warm air infiltration and frost buildup that can affect cooling performance
• Minimizes moisture and dust entry at door edges or panel seams
• Restores contact between mating surfaces to improve energy efficiency

• Clean and dry the mounting surface thoroughly before applying for best adhesion
• Measure and trim tape to fit; peel backing and press firmly in place along the seam or edge
• Replace only the lengths required; avoid stretching the tape during installation
• Disconnect power or follow manufacturer safety guidance

This door switch access cover replaces the plastic access panel that protects and secures the door latch/switch assembly behind the appliance door. It restores a finished appearance and helps keep the switch area safe and stable. What it does:

• Covers and secures the door switch area to prevent debris contact and accidental interference
• Helps maintain proper alignment of the door switch and latch components
• Stops light drafts and reduces rattles around the door switch opening
• Common symptom: cracked, broken, or missing cover causing loose switch or exposed switch components

• Disconnect power (unplug or switch off breaker) before starting any repair
• Remove the door inner panel or trim as needed to access the switch area; retain fasteners for reassembly
• Align cover over the switch opening and secure with the original screws/clips; do not overtighten
• If any switch or latch parts are damaged, inspect and replace those components separately