Parts for Kitchenaid KFDC558JMB01: 18" Oven Door Parts

This is the inner oven door glass that replaces a cracked, broken, or damaged panel to restore the oven door's seal and visibility. It provides a clear, heat-resistant viewing surface so you can check cooking progress without opening the door. What it does

• Replaces a damaged inner oven door glass panel to restore proper viewing and containment of heat.
• Helps reduce heat loss and prevents smoke or fumes from escaping through a broken door.
• Commonly used when the glass is cracked, shattered, fogged, or otherwise compromised.
• Restores safe operation and improves oven efficiency by re-establishing a proper door barrier.

• One inner oven door glass panel

• Disconnect power to the appliance before beginning any door disassembly.
• Handle glass with care and wear cut-resistant gloves and eye protection; glass edges may be sharp.
• Door disassembly is typically required; keep screws and brackets organized for reassembly.
• After installation, verify the door closes evenly and the oven heats properly before normal use.

This is a genuine replacement screw used to fasten appliance panels and components. It restores secure mounting where a missing or stripped screw causes loose panels or rattling. What it does

• Secures trim, panels, or internal components to prevent movement and vibration
• Replaces lost, damaged, or stripped fasteners that cause rattling or misalignment
• Provides the correct fit and thread engagement for the intended mounting point
• Helps restore safe, stable operation of the appliance

• One screw as shown

• Turn off and unplug the appliance before beginning any repair
• Use the correct screwdriver or driver bit to avoid stripping the head
• Replace only fasteners that match the original size and thread for secure fit
• If rust, thread damage, or fitting issues are present, replace all related fasteners.

This genuine replacement screw secures appliance components and restores proper fit where the original fastener has worn, stripped, or gone missing. It's a simple, reliable part to help stop rattling and keep panels and assemblies aligned. What it does:

• Fastens panels, brackets, or assemblies to maintain proper alignment and reduce vibration
• Replaces damaged, stripped, or missing screws to restore secure connections
• Helps eliminate rattling, loose trim, or gaps caused by a missing fastener
• Works where the appliance's original screw is required for proper fit

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Disconnect power and follow appliance safety procedures before accessing internal parts

This genuine replacement screw restores secure mounting of panels and components on Whirlpool appliances, helping stop loose or rattling parts and maintain proper fit. Small but essential fastener for routine repairs. What it does:

• Secures panels, trim, brackets or small components to appliance frames
• Replaces missing, damaged, or stripped screws that cause loose or misaligned parts
• Helps stop vibration noise and restore proper panel alignment
• Provides the correct thread and length for the original mounting location

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread or part damage
• Turn off and unplug the appliance before accessing internal components
• Keep removed fasteners organized so you return them to the original locations