Skip to Content
  • time delivery images 2 Day Quick Delivery!
  • box-refresh images 365 Day Return Policy!
  • lovely images 15 million satisfied customers
  • boxes images Over 2.1 Million Parts In Stock
  • headphone imagesFree Tech Support!
  • google images Google Trusted Store

Kenmore Washer 110.19101990 (11019101990, 110 19101990) Parts

Anti-Rattle Clip
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3355454

This anti-rattle clip adds light spring tension to keep a small component snug and quiet during operation. Replacing a bent or missing clip helps reduce vibration noise and maintains a secure fit of the attached part.

  • Applies tension to prevent rattling and buzzing during use
  • Helps keep the mounted piece properly seated and aligned
  • Common symptoms of failure: audible rattle, loose/wobbly component, missing or deformed clip
  • Simple, drop-in replacement where the original clip is used
What's included: 1 anti-rattle clip Install notes:
  • Disconnect power to the appliance before servicing
  • Note the original clip's orientation; transfer the new clip the same way
  • Use needle-nose pliers for placement; avoid over-bending the clip
  • The component is secure and clears adjacent parts before reassembly

Do-It-Yourself Stories from Customers like You My washer wouldn't go into a spin cycle.   Joshua P. • Cohutta , GA • April 18, 2021

I bought a clutch liner kit installed it in 5 minutes now it spins faster than ever. Read more

More
$5.95
Compare At:
$7.02
You Save:
$1.07

IN STOCK
Ships Today Guaranteed
Add to Cart
Rubber Washer
Genuine Whirlpool part
By: Whirlpool
Part Number: WP16123

Size: 1-1/16 x 5/8 inch. Used for fill hose. For a 4 pack order 285448A

This part fixes the following symptoms
  • Leaking
See more...
Do-It-Yourself Stories from Customers like You Water inlet valve was corroded and broken washer   Sandra H. • Belton , MO • June 26, 2015

Replaced with new part ordered from store Read more

More
$5.95
Compare At:
$7.08
You Save:
$1.13

IN STOCK
Ships Today Guaranteed
Add to Cart
Connector Housing (3-Circuit)
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2172937

This three-circuit connector housing organizes and protects terminals in an appliance wiring harness. It provides a secure, insulated plug connection to help prevent loose contacts, heat damage, and intermittent operation when the original housing is cracked or melted. What it does:

  • Holds three wiring terminals in the correct orientation for a mating connector
  • Insulates and locks terminals to reduce arcing and overheating at the plug
  • Replaces cracked, brittle, or heat-damaged connector housings
  • Symptoms can include intermittent power, burnt odor near the connector, discoloration/melting, or a plug that won't stay latched
What's included:
  • 1 three-circuit connector housing
Install notes:
  • Disconnect power before servicing the appliance
  • Note wire/terminal positions and transfer them one at a time into the new housing
  • Inspect terminals; replace any that are discolored, loose, or damaged. Use the correct crimp tool/terminals specified for your model
  • Fully seat each terminal until it locks and the connector latch engages securely

More
$13.48
Compare At:
$16.18
You Save:
$2.70

IN STOCK
Ships Today Guaranteed
Add to Cart
Screw
Genuine Whirlpool part
By: Whirlpool
Part Number: WP273556

Size: 10-16 x 5/8 inch.

Do-It-Yourself Stories from Customers like You Console screws were rusty and the other screw was broken.   Denis C. • Baltimore , MD • June 20, 2018

I used a screwdriver and removed all three screws and replaced them with ones I ordered from you. The job took less than ten minutes to complete. Read more

More
$5.95
Compare At:
$7.08
You Save:
$1.13

IN STOCK
Ships Today Guaranteed
Add to Cart
Appliance Spray Paint
Genuine Whirlpool part
By: Whirlpool
Part Number: 350956

Almond. Size: 13 oz. can. Acrylic appliance paint.

Do-It-Yourself Stories from Customers like You Age no money to fix it   Ronald V. • Cape Coral , FL • August 01, 2015

Was able to match it pretty well the natural age difference was good. The delivery of the product was amazing it took less than 24 hours to get to me and that was standard shipping. Give you guys an A for great !! Read more

More
$30.52
Compare At:
$36.32
You Save:
$5.80

IN STOCK
Ships Today Guaranteed
Add to Cart
External Drain Hose
Genuine Whirlpool part
By: Whirlpool
Part Number: 285666

Size: 8 foot long. This external washer drain hose is needed when there is more distance between the washer and the drain. Note: comes with 1.5" diameter clamp but hose is 1.25" in diameter; therefore you may need to order the 1.25" diameter clamp separately: WP356138

Do-It-Yourself Stories from Customers like You I was replacing the lid switch but decided to install a new vacuum break and drain hose while i was at it   Dianne Z. • Manchester , CT • May 27, 2016

Just took off the old vacuum break and put the new one on. It was very easy because the site had a video showing how and I watched it first. Read more

More
$44.95
Compare At:
$53.49
You Save:
$8.54

IN STOCK
Ships Today Guaranteed
Add to Cart
Drain Hose Extension
Genuine Whirlpool part
By: Whirlpool
Part Number: 285702

Size: 21 inches long. Clamp included.

Do-It-Yourself Stories from Customers like You Drain hose too short and home depot fix leaked   Sara B. • Liberty Hill , TX • August 21, 2015

Ordered a new drain hose and extension part. The prices including shipping were more reasonable than driving back and forth to the store just to piece meal parts together. Very frustrating. I ordered the parts that were specific to our washing machine, it took maybe 5 minutes to install, and everything fit perfectly. Now we're washing again and no leaks! Read more

More
$47.58

IN STOCK
Ships Today Guaranteed
Add to Cart
Wiring Harness Clip
Genuine Whirlpool part
By: Whirlpool
Part Number: WP90016

Used from harness to top.

Do-It-Yourself Stories from Customers like You A broken lid switch on my whirlpool stackable twin washer   Joseph P. • Indialantic , FL • October 25, 2016

Fixing the problem was quite simple. First, I removed the lid assembly (thanks to the diagrams supplied by AppliancePartsPros.com!). Getting the back two screws out was very difficult because I couldn't see them from the front and I could not move the unit out of the enclosed space. After some trial and error, I located the screws which were 5/16 hex head screws and removed them with a MAGNETIC nut driver. (The magnet assures that the screw will not drop down into the mechanism). Second, I... Read more

More
$7.44
Compare At:
$8.93
You Save:
$1.49

IN STOCK
Ships Today Guaranteed
Add to Cart
Connector (3 - Circuit)
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3360056

Used for the pressure switch.

Do-It-Yourself Stories from Customers like You Broken lid switch   Ari G. • State College , PA • June 01, 2015

Watched on line Video. Only problem was in disconnecting wire "bus" connector from switch. I was unable to remove connector without damaging it. I "jumped" connector to prove switch was faulty. This also allowed my wife to continue to do laundry while part arrived. I ordered a 3 circuit connector, but this was not the correct part. I ended up removing 3 wires from old broken connector and attaching them to new switch without a connector. Electrical tape did the trick. Not perfect... Read more

More
$12.61
Compare At:
$14.88
You Save:
$2.27

IN STOCK
Ships Today Guaranteed
Add to Cart
Lid Hinge
Genuine Whirlpool part
By: Whirlpool
Part Number: WP54583

Right hand side. For screws use WPW10119828.

Do-It-Yourself Stories from Customers like You Whirlpool washer   David L. • Linn , MO • August 31, 2015

With the parts supplied from your company. The lady that took my order was good at her job. All the parts were correct and fit. I thank you for the service that recieved. Read more

More
$19.50
Compare At:
$23.20
You Save:
$3.70

IN STOCK
Ships Today Guaranteed
Add to Cart
Tub Ring Seal
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3359586

This tub ring seal sits between the washer's outer tub and the tub ring. It creates a splash-resistant barrier at the top of the tub to keep wash water contained and help prevent leaks from the cabinet area.

  • Seals the perimeter joint between the tub ring and outer tub
  • Helps prevent water splashes from escaping during agitation and spin
  • May help if you notice water around the lid/top of the cabinet
  • Replace when the gasket is torn, brittle, or permanently compressed
What's included: 1 tub ring seal Install notes:
  • Unplug the washer and shut off the water supply before servicing
  • Lift the top or remove the cabinet to access the tub ring (varies by model)
  • Remove the tub ring; clean mating surfaces; seat the new seal evenly without twists
  • Reassemble and run a short fill/agitate test to check for leaks

More
$45.95
Compare At:
$55.14
You Save:
$9.19

IN STOCK
Ships Today Guaranteed
Add to Cart
Touchup-Alm
Genuine Whirlpool part
By: Whirlpool
Part Number: WP72107

Color: Almond

Do-It-Yourself Stories from Customers like You Broken meat drawer   Jesse B. • Stow , MA • January 26, 2015

Replaced. Shippping was very fast. A good experience. Read more

More
$14.95
Compare At:
$17.79
You Save:
$2.84

IN STOCK
Ships Today Guaranteed
Add to Cart
Gasket Sealer
Genuine Whirlpool part
By: Whirlpool
Part Number: WP285195

Size: .20 Fl. Oz. (6 ml)

More
$59.65
Compare At:
$71.58
You Save:
$11.93

IN STOCK
Ships Today Guaranteed
Add to Cart
Skate Plate
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3946509

Includes suspension pads.

More
$92.51
Compare At:
$110.61
You Save:
$18.10

IN STOCK
Ships Today Guaranteed
Add to Cart
Lid Hinge
Genuine Whirlpool part
By: Whirlpool
Part Number: WP54584

Left hand side.

Do-It-Yourself Stories from Customers like You Whirlpool washer   David L. • Linn , MO • August 31, 2015

With the parts supplied from your company. The lady that took my order was good at her job. All the parts were correct and fit. I thank you for the service that recieved. Read more

More
$20.95
Compare At:
$24.93
You Save:
$3.98

IN STOCK
Ships Today Guaranteed
Add to Cart
Clutch Spring Cap (Washer)
Genuine Whirlpool part
By: Whirlpool
Part Number: WP62646

This clutch spring cap retains and protects the clutch spring in your washer's drive/clutch assembly, maintaining proper tension. Replacing a worn or missing cap helps the clutch engage smoothly and reduces slipping and noise during spin.

  • Secures the clutch spring within the clutch assembly to prevent movement or dislodging
  • Maintains correct spring preload for consistent clutch engagement
  • Can help reduce clutch slip that appears as weak/no spin, slow spin ramp-up, or intermittent spinning
  • Common signs of trouble: rattling or scraping near the drive, burning smell, or a visibly damaged/missing cap
What's included: 1 clutch spring cap Install notes:
  • Unplug the appliance and shut off water before servicing
  • Access the clutch per your model's service procedure; removing the gearcase/transmission and clutch may be required
  • Carefully relieve spring tension and note the orientation of the spring and cap before removal
  • Inspect the spring, clutch lining, and related hardware; replace any worn components during reassembly

Do-It-Yourself Stories from Customers like You My washer wouldn't go into a spin cycle.   Joshua P. • Cohutta , GA • April 18, 2021

I bought a clutch liner kit installed it in 5 minutes now it spins faster than ever. Read more

More
$5.95
Compare At:
$7.08
You Save:
$1.13

IN STOCK
Ships Today Guaranteed
Add to Cart
  • boxes images Over 2.1 Million Parts In Stock
  • time delivery images 2 Day Quick Delivery!
  • box-refresh images 365 Day Return Policy!
  • headphone imagesFree Tech Support!
  • google images Google Trusted Store