Kenmore Washer 110.26942500 (11026942500, 110 26942500) Parts

Replacement clip for washer lid switch assembly. Replace if broken or loose to restore proper lid closure detection. Confirm fit with your model number.

Harness retainer secures wiring harnesses inside your washer cabinet. Replace if cracked, broken, or missing to properly route and protect wires.

Fix washer not filling or draining properly with this pressure switch hose harness clip. Secures the hose connection for accurate water level detection.

Can't adjust wash temperature? This rotary temperature selector switch restores manual temperature control in washers with worn or unresponsive controls.

Secures wire harness connections in your washer. Replace if clip is broken, missing, or wires are loose. Confirm fit with your model number.

Secures panels, hoses, and wiring in place to prevent rattling and loose components. Replace when worn or broken to restore proper fit. Confirm compatibility with your model number.

Two-piece washer sleeve kit for laundry centers. Replace worn, cracked, or missing sleeves to restore proper fit and protect components during operation.

Replacement mounting screw for dryers. Secures internal components and panels. Needed when screws are stripped, missing, or damaged during repairs.

Rear panel for your washer. Replaces cracked, dented, or rusted panels. Covers the back of the machine for a complete, finished appearance.

White intermediate washer component for your washer's agitator assembly. Replace if worn, cracked, or causing noise during wash cycles. Verify fit with your model.

Suspension spring for washer drum support system. Replaces broken, stretched, or missing springs that cause instability. Direct fit component.

This cabinet top panel replaces the appliance's upper exterior surface to restore a flush fit and finished appearance. It protects internal components and helps maintain proper alignment of the control area and lid/door. What it does:

• Covers and protects the appliance cabinet's upper area from debris, spills, and wear
• Provides a mounting surface and alignment for the control assembly and lid/door
• Stops drafts, reduces rattling, and restores a uniform exterior fit and finish
• Addresses symptoms such as gaps at the top, loose or misaligned control area, or visible surface damage

• Disconnect power (and water supply for washers) before beginning any work.
• Removal/installation may require removing the control console or front/side trim; keep screws and small parts organized.
• Align tabs and screw holes carefully to avoid scratching the finish; hand-start fasteners before tightening.
• Inspect and replace sealing or trim pieces if damaged to ensure a proper fit.

Decorative nameplate medallion for your washer. Mounts on the control panel or cabinet front. Replace if cracked, faded, peeling, or missing.