Kenmore Washer 110.47531701 (11047531701, 110 47531701) Parts

This water level pressure switch senses air pressure from the tub and signals the control to stop filling at the correct level. Replacing a weak or failed switch restores proper filling, helps prevent over/underfilling, and allows cycles to advance.

• Monitors tub water level via the pressure hose and sends the level signal to the control
• Stops water flow at the target level so wash, rinse, and spin can begin
• Common symptoms of a failing switch: continuous filling, overfilling or underfilling, cycle won't advance past fill/sensing, or stops with water still in the tub
• A cracked, kinked, or blocked pressure hose can mimic switch failure—inspect during diagnosis

• Disconnect power and turn off water supply before servicing
• Access the switch from the console/top or rear panel per your model; note wire orientation
• Transfer and firmly seat the pressure hose; inspect it for kinks, cracks, or blockages and replace if damaged
• After installation, run a fill test; some models may require a diagnostic calibration—see the tech sheet or user manual

This replacement counterweight helps balance and stabilize a refrigerator or freezer door so it opens and closes smoothly and stays properly aligned. It restores correct door movement and reduces sag that can interfere with sealing or latching. What it does:

• Balances the appliance door to prevent drooping and uneven closing
• Helps the door stay open or closed as designed for safer access
• Reduces stress on hinges and latch mechanisms from misaligned doors
• Can eliminate symptoms like a sagging door, difficulty latching, or uneven gaps

What's included: One counterweight. Install notes:

• Disconnect power to the appliance before starting any work.
• Support the door securely while removing/installing the counterweight to avoid injury or damage.
• Installation may require basic hand tools and removal of trim or hinge hardware; follow the OEM service instructions for your model.
• After installation, check door alignment and latch engagement; adjust hinge hardware per manufacturer guidance if needed.