Kenmore Washer 110.47532601 (11047532601, 110 47532601) Parts

Genuine Whirlpool part

Counterweight (Door)

By: Whirlpool

Part Number: W10200296

This replacement counterweight helps balance and stabilize a refrigerator or freezer door so it opens and closes smoothly and stays properly aligned. It restores correct door movement and reduces sag that can interfere with sealing or latching. What it does:

Balances the appliance door to prevent drooping and uneven closing
Helps the door stay open or closed as designed for safer access
Reduces stress on hinges and latch mechanisms from misaligned doors
Can eliminate symptoms like a sagging door, difficulty latching, or uneven gaps

What's included: One counterweight. Install notes:

Disconnect power to the appliance before starting any work.
Support the door securely while removing/installing the counterweight to avoid injury or damage.
Installation may require basic hand tools and removal of trim or hinge hardware; follow the OEM service instructions for your model.
After installation, check door alignment and latch engagement; adjust hinge hardware per manufacturer guidance if needed.

Genuine Whirlpool part

Dispenser

By: Whirlpool

Part Number: WP8540058

Genuine Whirlpool part

Console

5.0 (1)

By: Whirlpool

Part Number: WPW10099604

Do-It-Yourself Stories from Customers like You Broken plastic bubbles over power and start buttons on console. Harold W. • Colorado Springs , CO • July 16, 2019

Ordered and installed console Read more

Genuine Whirlpool part

Hinge

By: Whirlpool

Part Number: WPW10118967

Genuine Whirlpool part

Wire Harness

4.0 (1)

By: Whirlpool

Part Number: WPW10184855

Do-It-Yourself Stories from Customers like You F28 code serial communication error Mark H. • Peoria , AZ • March 04, 2016

The washer drum would intermittently not spin at initial start. Sometimes it would quit during a spin cycle and leave clothes wet. The problem became more frequent until it would no longer spin. Inspection revealed that the MCU connector (3 blue wires) was broken. This is the communication between MCU and the the CCU (Connected at the MI3) I replaced the entire main wire assembly? This was my first time I worked on this washer. If this is your first attempt to do the same, recommend taking... Read more