Kenmore Washer 110.47561601 (11047561601, 110 47561601) Parts

Genuine Whirlpool part

Water Level Pressure Switch

By: Whirlpool

Part Number: W11417619

This water level pressure switch senses air pressure from the tub and signals the control to stop filling at the correct level. Replacing a weak or failed switch restores proper filling, helps prevent over/underfilling, and allows cycles to advance.

Monitors tub water level via the pressure hose and sends the level signal to the control
Stops water flow at the target level so wash, rinse, and spin can begin
Common symptoms of a failing switch: continuous filling, overfilling or underfilling, cycle won't advance past fill/sensing, or stops with water still in the tub
A cracked, kinked, or blocked pressure hose can mimic switch failure—inspect during diagnosis

What's included: 1 water level pressure switch Install notes:

Disconnect power and turn off water supply before servicing
Access the switch from the console/top or rear panel per your model; note wire orientation
Transfer and firmly seat the pressure hose; inspect it for kinks, cracks, or blockages and replace if damaged
After installation, run a fill test; some models may require a diagnostic calibration—see the tech sheet or user manual

Do-It-Yourself Stories from Customers like You Washing machine F8 E1 error code Michael R. • Brooklyn , NY • June 02, 2018

The error code indicated the washer wasn't getting any water, although the basket was filling to an unusually high level. After checking the inlet hoses and their connections but without opening the top cover to see the actual water level pressure switch, I went ahead and ordered the part. After receiving the switch, I opened the cover and found the original switch had fallen off it's mounting (for who-knows how long ago) and was resting against the drum. Over time, the movement of the drum... Read more

Genuine Whirlpool part

Screw

By: Whirlpool

Part Number: 8182214

Genuine Whirlpool part

Ball

5.0 (1)

By: Whirlpool

Part Number: 8540013

Do-It-Yourself Stories from Customers like You I was getting f22 error Dat N. • Huntington Beach , CA • August 19, 2016

After draining the plug multiple times, I accidentally touched the water pump and it was hot. Replaced the water pump and all is good. Read more

Genuine Whirlpool part

Support

By: Whirlpool

Part Number: 8540342

Genuine Whirlpool part

Screw-Kit

By: Whirlpool

Part Number: W10182109

Genuine Whirlpool part

Wire Harness

5.0 (1)

By: Whirlpool

Part Number: W10184856

Do-It-Yourself Stories from Customers like You F 24 John M. • Cottage Grove , MN • May 17, 2015

Replaced the wire harness and water temp sensor. Took me most of an afternoon but it's back to running like new again! Read more

Genuine Whirlpool part

Counterweight (Door)

By: Whirlpool

Part Number: W10200296

This replacement counterweight helps balance and stabilize a refrigerator or freezer door so it opens and closes smoothly and stays properly aligned. It restores correct door movement and reduces sag that can interfere with sealing or latching. What it does:

Balances the appliance door to prevent drooping and uneven closing
Helps the door stay open or closed as designed for safer access
Reduces stress on hinges and latch mechanisms from misaligned doors
Can eliminate symptoms like a sagging door, difficulty latching, or uneven gaps

What's included: One counterweight. Install notes:

Disconnect power to the appliance before starting any work.
Support the door securely while removing/installing the counterweight to avoid injury or damage.
Installation may require basic hand tools and removal of trim or hinge hardware; follow the OEM service instructions for your model.
After installation, check door alignment and latch engagement; adjust hinge hardware per manufacturer guidance if needed.