Kenmore Dryer 110.6117203 (1106117203, 110 6117203) Parts

Dryer not blowing hot air or making noise? This fan belt drives the blower to restore airflow. DIYers replace it in under 30 minutes with basic tools.

Cage nut clips into panel openings to create a threaded anchor point for secure mounting. Replace if broken, stripped, or missing to restore hardware.

Replacement machine bolt for securing panels, brackets, and components in dishwashers, dryers, washers, and laundry centers. Restores fit if missing.

Mounting screw for dryer assembly and panel attachment. Replace if screw is stripped, missing, or damaged during disassembly. Secures components.

Base mounting screw for vacuum cleaners. Secures the bottom housing and internal components. Replace if screw is stripped, missing, or loose.

Flat metal washer distributes load and maintains proper alignment between fasteners and components. Replace when worn, corroded, or missing. Confirm fit with your model number.

Compression nut for dryer installation. Secures hoses and connections. Replace if stripped, corroded, or missing to ensure proper assembly and fit.

Ground wire clip for ranges and ovens. Secures grounding wire to chassis. Replace if clip is broken, bent, or missing to ensure proper electrical ground.

Tail pipe for dryer stack kit installation. Connects stacked dryer to water supply or drain. Replace if cracked, leaking, or missing from kit.

Dryer not heating? A faulty gas valve assembly often causes no heat or inconsistent heating. Moderately difficult repair requiring basic tools and safety.

Seals unused pipe openings in your washer to prevent leaks and debris entry. Replace if damaged, cracked, or leaking to restore watertight closure.

Hinge pad cushions the dryer door hinge connection. Replace if your original pad is cracked, worn, compressed, or missing to restore proper door support.

Secures hoses to prevent leaks in your washer. Replace if loose, cracked, or causing water leakage. Verify compatibility with your model number.

This kit secures the lower toe/kick panel to the front of the appliance, keeping the panel tight and properly aligned. Replacing worn or missing clips restores a secure fit and makes access for service straightforward.

• Holds the toe/kick panel in place at the base of the cabinet
• Helps prevent panel rattling, gaps, or a loose/hinging lower panel
• Common fix when the lower panel won't stay secured after service
• Durable metal clip design for repeated panel removal and reattachment

• Unplug appliance before servicing; wear gloves to avoid sharp edges
• Support the toe panel while releasing old clips to prevent bending
• Install clips in the cabinet slots first, then engage the panel into the clips
• Verify the panel is fully seated on both sides before restoring power

Right side