Kenmore Dryer 110.76960830 (11076960830, 110 76960830) Parts

Genuine Whirlpool part

Timer Knob

By: Whirlpool

Part Number: WP688865

Color: Chrome. Measures about 2 inches in diameter.

Do-It-Yourself Stories from Customers like You The control knob for the dryer broke John J. • Lilly , GA • August 08, 2014

Ordered a new control knob. Took less than 2 minutes to install new knob. Read more

Genuine Whirlpool part

Dryer Door Hinge

5.0 (2)

By: Whirlpool

Part Number: WP238456

Right side

Do-It-Yourself Stories from Customers like You Our dryer had a broken latch and bad hinges Lawrence G. • St. Clair , MO • November 13, 2015

After watching a video on the Alliance Parts Pros website, I was able to easily fix the problem, quickly and easily. Read more

Genuine Whirlpool part

This left-side guide cable helps position and stabilize the appliance component it supports, restoring smooth movement and alignment for reliable operation. Designed to replace a worn or broken guide cable and reduce binding or misalignment. What it does:

Guides and supports the component assembly on the left side to maintain correct travel and alignment
Replaces damaged or frayed cable that can cause sticking, jerking, or uneven movement
Helps restore smooth operation and consistent performance of the guided assembly
Works as the matching left-side counterpart when paired with its right-side guide

What's included:

One left-side guide cable

Install notes:

Follow the appliance manufacturer's service instructions and disconnect power before beginning work
Handle cable ends and attachment points carefully to avoid fraying or damage during installation
Verify routing and attachment points match the original cable for correct operation

Genuine Whirlpool part

Guide Right

By: Whirlpool

Part Number: WP337183

Genuine Whirlpool part

Cable

By: Whirlpool

Part Number: 230131

Genuine Whirlpool part

Handle

5.0 (1)

By: Whirlpool

Part Number: WP3977746

Do-It-Yourself Stories from Customers like You The lever to turn on dryer was broken the handle was broken and the latch was broken David R. • Jemison , AL • February 09, 2015

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more