Kenmore Washer 110.94570800 (11094570800, 110 94570800) Parts

Use with motor 357282.

This lid switch is the user-replaceable electrical switch that detects when a washer lid is closed so the cycle can run. Replacing a faulty switch restores normal start, spin and agitation safety interlock function. What it does

• Detects lid closure and signals the washer control to allow start, spin and agitation.
• Prevents the washer from spinning or agitating when the lid is open.
• Common symptom: washer won't start, won't spin or won't agitate.
• Works as the safety/interlock component tied to the washer's main control.

• One lid switch assembly.

• Always unplug the washer before inspecting or replacing electrical parts.
• Verify power is off and test the old switch with a multimeter if you can before replacement.
• Basic hand tools are typically required; follow your model's service instructions for access.

Motor mount to gear case.

For mating plug use 691707.

Color: White. Size: 1 qt. can. Acrylic appliance paint.

This lid assembly replaces a damaged or discolored top lid so your washer closes properly and looks like new. It restores the washer's top cover, improving cosmetic appearance and allowing the lid switch and hinge to function correctly. What it does:

• Replaces a cracked, warped or broken top lid that won't close or latch securely
• Restores the mounting surface for the lid switch and hinge so the washer can operate safely
• Improves the washer's appearance when the original lid is chipped, scratched, or yellowed
• Helps prevent dirt and debris from entering the tub area

• One lid assembly

• Disconnect power to the washer before starting any repair to avoid shock or injury
• Remove any screws or hinge pins securing the old lid; keep track of fasteners and springs
• Lift the old lid off the hinges and set the new lid into place, reinstalling hardware securely
• If the lid switch or hinge hardware is damaged, replace those parts separately.

Color: White.

Installation instructions included.

Washer tub ring that snaps onto the top of the outer tub. It acts as the tub cover and splash guard, guiding water back into the tub and supporting inlet or dispenser fittings to help keep the rim area contained.

• Attaches to the top of the outer tub as the upper splash guard/tub cover
• Directs water back into the tub; supports inlet/dispenser nozzles, if equipped
• Maintains proper clearance around the spin basket
• Common replacement signs: cracks, broken locking tabs, splashing from the rim, or rubbing at the top opening

What's included: 1 tub ring Install notes:

• Disconnect power and water supplies before servicing
• Lift or remove the top panel to access the tub rim
• Release locking tabs and detach any hoses/nozzles from the old ring; transfer fittings if needed
• Seat the new ring evenly; ensure all tabs fully engage. Reassemble and run a test cycle to check for leaks/splashing