Kenmore Freezer 198.616480 (198616480, 198 616480) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP965173
Replacement 8-18 thread screw for securing panels, brackets, and trim on appliances. Replace worn, stripped, or missing screws to keep components aligned.
More
$6.77
- Compare At:
-
$8.06
- You Save:
-
$1.29
Genuine Whirlpool part
By: Whirlpool
Part Number: 876370
Foam insulation panel that fits inside refrigerator doors to maintain temperature efficiency. Replace if cracked, compressed, or missing.
More
$109.95
- Compare At:
-
$130.84
- You Save:
-
$20.89
Genuine Whirlpool part
By: Whirlpool
Part Number: W10759522
Replacement mounting screw for dryers. Secures internal components and panels. Order a new screw if yours is stripped, lost, or damaged during repair.
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: WP505587
Putty sealer adhesive for refrigerators and freezers. Seals joints, gaps, and connections. Replace when old sealant is cracked, dried out, or missing.
Do-It-Yourself Stories from Customers like You
High level of noise with each compressor cycle Bruce H. • Bonita Springs , FL • July 24, 2015
The installation of the new condenser motor was as the video described; there were no surprises. I noted the difference in operation immediately, the fan was moving at a higher rate of speed in a smoother motion. The new motor had far less shaft end play and seems to move more air across the condenser coil than the original motor. All in all, this was a relatively easy repair that solved a real refrigerator performance problem; the unit now cycles less often and generates less compressor heat.
Read more
More
$77.44
- Compare At:
-
$91.38
- You Save:
-
$13.94
Genuine Whirlpool part
By: Whirlpool
Part Number: WP509986
Shelf support stud secures refrigerator shelves to interior walls. Replace if broken, cracked, or missing to restore proper shelf mounting and stability.
More
$5.49
- Compare At:
-
$6.53
- You Save:
-
$1.04
Genuine Whirlpool part
By: Whirlpool
Part Number: WP596788
Plastic rivet secures door seals and gaskets to refrigerator or freezer doors. Replace broken, cracked, or missing rivets to restore proper seal alignment.
Do-It-Yourself Stories from Customers like You
Light out and missing seal holders Richard E. • Round Rock , TX • November 22, 2020
Replaced light and installed seal locks. Works great.
Read more
More
$9.95
- Compare At:
-
$11.94
- You Save:
-
$1.99
Genuine Whirlpool part
By: Whirlpool
Part Number: W10873798
Replace your burned-out or flickering appliance light bulb to restore interior visibility. Fits compatible refrigerators, freezers, and microwaves.
Do-It-Yourself Stories from Customers like You
Light bulb out in a chest freezer Howert C. • Fullerton , CA • January 04, 2021
Had to find the correct bulb for a Kenmore freezer. AppliancePartsPros made it east with the feature that lets you verify the model number of the freezer to the correct size light bulb. Great feature.
Read more
More
$14.65
- Compare At:
-
$17.43
- You Save:
-
$2.78
Genuine Whirlpool part
By: Whirlpool
Part Number: 606755
Replaces a cracked or damaged envelope on your heater. This structural component protects internal parts and ensures proper operation. Order now.
More
$46.95
- Compare At:
-
$55.40
- You Save:
-
$8.45
Genuine Whirlpool part
By: Whirlpool
Part Number: 799344
White acrylic touch-up paint for appliances. Covers scratches, chips, and scuffs on refrigerators, washers, dryers, and ranges. 1-quart can restores finish.
More
$102.95
- Compare At:
-
$121.48
- You Save:
-
$18.53
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: WP120393
Flat washer for washers. Installs between components to distribute load and prevent surface damage. Replace if worn, cracked, or missing during repairs.
More
$4.73
- Compare At:
-
$5.58
- You Save:
-
$0.85
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: WP4317852
The Alumilastic Cement is an OEM part for Whirlpool appliances, typically used in refrigerators and freezers. It serves as a thermal mastic compound, designed to provide a secure and heat-conductive bond between various components, such as evaporator coils and the interior walls of the appliance.
Causes of a bad alumilastic cement can include drying out, cracking, or losing its adhesive properties over time. This can occur due to age, exposure to temperature fluctuations, or improper application. When the cement fails, it can lead to poor thermal conductivity and decreased cooling efficiency.
Symptoms of a bad alumilastic cement include:
- Reduced cooling performance
- Unusual noises from the cooling system
- Components becoming loose or detaching
- Increased energy consumption
This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Do-It-Yourself Stories from Customers like You
Ice maker wouldnt make ice Ty G. • Lewis Center , OH • December 30, 2014
I used your online troubleshooting tips and watched the videos on your site. I determined my thermostat was defective, ordered the thermostat which arrived in two days and I replaced the thermostat and I now have a full bin of ice !!!
The do it yourself video was extremely helpful and made the repair very easy.
Thanks so much for the great service and quick delivery !!!
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 486146
Genuine Whirlpool part
By: Whirlpool
Part Number: WP628210
Do-It-Yourself Stories from Customers like You
Ice maker leaking water into the ice tray David M. • Wayne , PA • September 04, 2015
Replaced broken gear
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 569869
Genuine Whirlpool part
By: Whirlpool
Part Number: 576662
Genuine Whirlpool part
By: Whirlpool
Part Number: 592121
Do-It-Yourself Stories from Customers like You
Indicator light wasn't working Alan M. • Vail , AZ • January 02, 2015
I simply popped old clip out with my fingernail. Then pulled the connection straight apart,noteing the location of internal parts (diode,bulb ).Reconnect the new part noteing same location as before.Not sure if this step is necessary, but it can't hurt. Push wires back in and snap clips in place. Took about 3 minutes!
Read more
More