Kenmore Refrigerator 253.44353405 (25344353405, 253 44353405) Parts

This genuine OEM part is the main control board for refrigerators. The main control board is the primary circuit board that controls the refrigerator's essential functions of maintaining and controlling temperature. If the refrigerator is no longer staying cool, powering on, or maintaining proper temperature, the main control board will need to be replaced. To begin, start by unplugging the refrigerator. Once unplugged, proceed to uninstall the inner door panel of the refrigerator by removing the mounting screws. Once removed, access the old control board. Remove the wire harness and any individual wires attached to the old board. After that, pull the old board out of its mounting brackets to fully remove it from the refrigerator. Reinsert the wires into their correct terminals on the new board and snap it into its mounting brackets. Once secured, reinstall the inner panel of the refrigerator and restore power to the appliance. This authentic replacement part is sold individually and is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, and Westinghouse brand refrigerators.

This wiring harness routes power and signals between the appliance control and its components, restoring reliable electrical connections for proper operation. Use this direct-fit replacement when the original harness is damaged or intermittent. What it does

• Provides dedicated wiring between the main control and motors, valves, switches or sensors
• Replaces brittle, frayed or burned wires that can cause intermittent operation or failed components
• Restores missing circuits that prevent the appliance from starting or running specific functions
• Helps stop electrical arcing and loss of connectivity when the original harness insulation is compromised

• One wiring harness

• Disconnect power (unplug or switch off breaker) before beginning any repair
• Compare new harness to the old unit to verify routing and connector fit before installation
• Route and secure the harness away from moving parts and heat sources; use existing clips and ties
• If connectors are corroded or pins are damaged, replace connectors