Kenmore Dishwasher 587.1507181 (5871507181, 587 1507181) Parts

This replacement door gasket creates a tight seal around the refrigerator door to help maintain proper cooling and reduce energy waste. It restores the door's sealing surface for more consistent temperatures and less moisture buildup. What it does:

• Seals the door perimeter to keep cold air in and warm air out
• Helps prevent frost and ice buildup inside the compartment
• Reduces excessive run time from the compressor caused by air leaks
• Minimizes condensation and food spoilage linked to poor door sealing

• Disconnect power to the appliance before starting any work
• Remove the old gasket and clean the gasket channel and mounting surface
• Align and seat the new gasket evenly around the door; start at corners for best fit
• After installation, allow the gasket to set and check for gaps; adjust as needed

This wash impeller is the pump rotor that moves dishwasher wash water through the circulation system to help clean dishes. Replacing a worn impeller restores proper water flow and improves cleaning performance. What it does:

• Spins on the wash pump shaft to push water through spray arms for effective cleaning
• Helps maintain proper spray pressure during the wash cycle
• Worn or damaged impeller can cause weak spray, poor cleaning, or unusual pump noise
• Works with the pump housing and seals to keep water circulating where it belongs

• One wash impeller

• Disconnect power and water supply before beginning any repairs
• Access the lower pump assembly by removing the lower access panel and spray arm(s)
• Inspect pump housing and seals; replace any damaged gaskets to prevent leaks
• Reassemble carefully and run a test cycle to check for proper operation and leaks

This replacement part is a fastener, and it is intended for use in different types of appliances. This is a genuine replacement part made by Frigidaire. Fasteners are a small metal part that is used in many spots in refrigerators or freezers. These clips are able to help keep shelving and other items in place so that the appliance works properly. A new fastener might be needed if there are any parts of the fridge or freezer that are loose or falling off. The fasteners allow the shelving and other attachments to stay steady, so if anything is not attached properly, it might be time to replace the fasteners. It is possible that the fasteners might become brittle over time as they are typically held in cool or freezing conditions. Many appliances require more than one fastener so be sure that the correct amount is ordered. This fastener is sold individually and is compatible with appliances made by Frigidaire. Also note that this part is a genuine OEM replacement part.

This bolt kit provides the replacement fasteners needed to secure appliance panels and components, restoring proper fit and reducing noise from loose parts. Designed to match OEM fastener sizes for an exact fit. What it does:

• Replaces missing or damaged bolts and screws used on appliance panels, brackets, or assemblies
• Restores secure mounting to stop rattling, vibration, or shifting panels
• Helps ensure components stay aligned for proper operation
• Provides the correct fastener types to match original mounting points

• Disconnect power or gas to the appliance before beginning any service
• Use the proper hand tools and torque carefully; do not overtighten fasteners
• Keep track of existing parts during disassembly and match fasteners to their original locations