Kenmore Dishwasher 665.13269K110 (66513269K110, 665 13269K110) Parts

This replacement manifold routes water inside the appliance so spray arms and wash chambers receive the proper flow for cleaning. Replaces a worn or cracked manifold to restore proper water distribution and reduce leaks. What it does:

• Directs inlet water to spray arms and internal wash channels for normal wash cycles
• Helps maintain consistent water flow for effective cleaning performance
• Stops or reduces leaks when replacing a cracked or damaged manifold
• Resolves symptoms like weak or no spray, water pooling, or visible leaks

• One replacement manifold

• Install requires access to the appliance interior and removal of panels—disconnect power and water before starting
• Tighten fittings to manufacturer torque recommendations and check for leaks after installation
• Inspect related hoses, clamps, and seals and replace if brittle or damaged

A replacement control bracket that secures the console/control assembly to the appliance frame so buttons, knobs and the control board stay properly aligned. Restores stable mounting and reduces rattling or misalignment. What it does:

• Holds the control panel/console in the correct position on the appliance frame
• Keeps the control board and user interface securely mounted to prevent movement
• Helps eliminate rattling, vibration noise or intermittent contact caused by loose mounting
• Provides the proper mounting points for screws and other fasteners

• One control bracket

• Disconnect power to the appliance before beginning any repair
• Remove the console or trim as needed to access the bracket; keep all screws and fasteners
• Secure with the original fasteners; do not overtighten
• If the control board or wiring is exposed, handle electronics carefully and avoid contact with conductive tools

This replacement silverware basket sits in the dishwasher rack and keeps forks, knives, and spoons upright and contained so they wash thoroughly and don't slip through the rack or interfere with spray-arm movement. What it does:

• Holds and organizes flatware during wash and rinse cycles
• Helps separate utensils for better spray coverage and drainage
• Replaces cracked, warped, or missing baskets

• 1 silverware basket

• Open the dishwasher and pull out the lower rack for access
• Lift out the old basket and place the new basket in the same location/orientation
• Ensure the basket seats securely and does not contact the lower spray arm
• Manually spin the spray arm to confirm clearance before running a cycle

This handle pocket is the small insert that finishes the end of select appliance door handles and retains the KM 2.5-inch medallion. Replace a cracked or missing pocket to restore a secure hold and a clean, factory look.

• Retains the KM 2.5-in medallion at the handle end
• Provides a finished appearance and helps cover internal fasteners
• Helps keep the handle end secure to reduce looseness or rattles
• Typical symptoms: loose or missing medallion, cracked pocket, damaged/unfinished handle end

• Disconnect power to the appliance before servicing
• Access the handle end; remove any set screw(s) or trim as required
• Seat the new pocket, transfer the existing medallion, and resecure hardware
• Do not overtighten fasteners; verify the handle is secure and aligned

Color: Biscuit. Size: 1 qt. can uncut. Enamel paint.

Color: White. Other colors: For black use 8171657, for biscuit use 8171657.For stainless use 8171659

Color: Black. Other colors: For white use 8171656, for biscuit use 8171657, for stainless steel use 8171659.

Color: Stainless steel. Other colors: For black use 8171657, for white use 8171656, for biscuit use 8171658.