Kenmore Dishwasher 665.14213K900 (66514213K900, 665 14213K900) Parts

This heater support secures the dryer heater assembly so it stays aligned and stable during operation, helping maintain proper airflow and heating performance. It's a direct-fit replacement designed to restore correct heater positioning. What it does:

• Holds the heater assembly in place to prevent shifting or contact with other components
• Helps maintain proper airflow path for efficient drying and consistent heat
• Reduces rattling, rubbing, or intermittent heating caused by a loose heater
• Works with the heater housing and mounting points to keep electrical and thermal parts separated

• Refer to the dryer's service manual or parts diagram for correct placement and orientation
• Disconnect power before starting work to avoid electrical shock
• Inspect surrounding clips, screws, and the heater assembly; replace any damaged fasteners

Color: Black.

This small black clamp secures a hose, tube or wiring harness to prevent movement and abrasion. It's a direct-fit replacement used to keep connections stable so lines stay routed and protected during normal appliance operation. What it does

• Holds small hoses, tubing or wiring harnesses firmly in place
• Prevents chafing and accidental disconnection from vibration or movement
• Helps maintain routing to reduce stress on attached components
• Commonly used where a compact, non-corrosive clip is required

• Disconnect power before servicing any electrical appliances
• Use appropriate hand tools; avoid over-tightening which can damage hoses

Size: 8-32.

This drain cover seal creates a watertight gasket between the washer's drain cover and housing to help stop leaks and keep lint and debris out of the drain pump area, restoring reliable drainage and reducing mess. What it does:

• Seals the drain cover to prevent water from leaking at the base of the tub or access area.
• Helps block lint, coins and small debris from entering the drain pump housing.
• Restores proper drainage by maintaining a secure, even seal around the drain opening.
• Can reduce recurring puddles or water on the floor near the washer's front/bottom.

• Disconnect power and turn off water supply before starting work.
• Remove the drain cover/access panel per your model's instructions and clean mating surfaces before installing the new seal.
• Press or seat the seal evenly into the cover/housing; confirm correct orientation and full contact around the perimeter.
• After reassembly, restore power/water and run a short test cycle to check for leaks.

The Latch Switch Kit, an OEM Replacement Part is designed to ensure the safe operation of your Whirlpool dishwasher. The kit includes two microswitches and a wiring harness. It prevents the appliance from running when the door is open. If defective, the door switch may prevent the dishwasher from operating even when the door is closed.

Causes of a bad door switch can include wear and tear, exposure to moisture, or a broken actuator.

Symptoms of a bad door switch include:

• Dishwasher not starting
• Dishwasher stopping mid-cycle
• Error codes related to door issues
• Dishwasher running with the door open

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.