Kenmore Dishwasher 665.17722K900 (66517722K900, 665 17722K900) Parts

Optional accessory. Color: White.

This console is the exterior control panel assembly that holds the dryer or washer controls and display, restoring a secure, user-friendly interface and improving operation when the original panel is damaged or worn. What it does:

• Houses push buttons, knobs, and/or electronic display used to select cycles and settings
• Protects the internal control board and wiring from dirt, moisture, and impact
• Replaces cracked, broken, or faded control surfaces that make selections hard to read or use
• Restores a solid mounting surface for user controls and prevents loose or intermittent button operation

• Disconnect power before starting any work
• Handle the console carefully to avoid scratching the finish or damaging attached wiring and connectors
• Some models require removing the top or front panel to access mounting screws—keep fasteners and trim pieces organized
• If the console contains electronic components, avoid static discharge and reconnect all harnesses securely before testing

Size: 8-32.

This drain cover seal creates a watertight gasket between the washer's drain cover and housing to help stop leaks and keep lint and debris out of the drain pump area, restoring reliable drainage and reducing mess. What it does:

• Seals the drain cover to prevent water from leaking at the base of the tub or access area.
• Helps block lint, coins and small debris from entering the drain pump housing.
• Restores proper drainage by maintaining a secure, even seal around the drain opening.
• Can reduce recurring puddles or water on the floor near the washer's front/bottom.

• Disconnect power and turn off water supply before starting work.
• Remove the drain cover/access panel per your model's instructions and clean mating surfaces before installing the new seal.
• Press or seat the seal evenly into the cover/housing; confirm correct orientation and full contact around the perimeter.
• After reassembly, restore power/water and run a short test cycle to check for leaks.

The Latch Switch Kit, an OEM Replacement Part is designed to ensure the safe operation of your Whirlpool dishwasher. The kit includes two microswitches and a wiring harness. It prevents the appliance from running when the door is open. If defective, the door switch may prevent the dishwasher from operating even when the door is closed.

Causes of a bad door switch can include wear and tear, exposure to moisture, or a broken actuator.

Symptoms of a bad door switch include:

• Dishwasher not starting
• Dishwasher stopping mid-cycle
• Error codes related to door issues
• Dishwasher running with the door open

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.