Kenmore Dryer 796.91532110 (79691532110, 796 91532110) Parts

Metal mounting bracket that secures internal dryer components to the frame. Replace if cracked, bent, or broken to restore proper alignment and stability.

Base bracket for dryer installation and structural support. Replace if your original bracket is cracked, broken, bent, or missing to restore proper stability.

Mounting bracket that secures internal dryer components. Replace if cracked, broken, or missing to restore proper alignment and stability of assemblies.

Dryer won't turn on or power up? This power cord assembly restores electrical connection when the cord is damaged, frayed, or faulty. Easy install.

Holder assembly for dryer door catch mechanism. Snaps into place to secure the magnetic door plunger. Replace if broken, cracked, or missing latches.

Burner guide for gas dryers. Directs flame positioning in the burner assembly. Replace if cracked, broken, or missing to restore proper burner operation.

Dryer won't tumble or makes loud noise? This complete drum assembly restores proper rotation and quiet operation. Major repair, 2-3 hours for experienced DIYers.

Snap-in hole cap covers unused openings on your dryer cabinet or control panel. Replace cracked, broken, or missing caps to restore a finished look.

Control knob assembly for dryer timer or cycle selector. Installs on control panel. Replace if knob is cracked, broken, won't turn, or missing.

This balance weight is the washer counterweight that helps stabilize the tub during spin cycles to reduce vibration and noise. Replaces a worn or damaged weight to restore smoother, quieter operation. What it does:

• Counterbalances the washer drum to minimize shaking and excessive movement during spin cycles
• Helps prevent banging or knocking noises caused by an unbalanced tub
• Supports even load distribution to reduce stress on suspension components
• Used when a cracked, loose, or missing weight is causing vibration issues

• One balance weight (counterweight)

• Disconnect power and water supply before starting any repair
• Support the tub or cabinet when removing/installing the weight to avoid sudden movement
• Tighten mounting hardware to OEM torque if specified; use the factory fasteners when available

This outer door frame replaces the cosmetic trim that surrounds the microwave door, restoring appearance and helping the door seal and latch properly. It's a direct-fit exterior component for a clean, finished look. What it does:

• Replaces damaged, dented or cracked outer door trim that affects the door's appearance
• Restores proper alignment and support for the door's outer assembly
• Helps maintain a consistent exterior finish and protects internal door components
• Commonly used when the door shows visible wear, cracks, or cosmetic damage

• Designed for direct replacement; follow the microwave's service manual for disassembly and reassembly steps
• Disconnect power to the appliance before beginning work to avoid electrical hazards
• Handle the door and frame carefully to avoid scratching the finish; use soft protection and non-marring tools