Parts for Frigidaire EPWD15SS1: 03 - Pedestal Parts

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic

This door strike mounts on the appliance door and engages the latch/lock to keep the door securely closed so the cycle can start. Replace a worn or broken strike to restore reliable door closure and operation.

• Engages the door latch/lock assembly to secure the door during use
• Enables the control to recognize a closed door so the unit can run
• Wear or damage can cause a door that won't close, "door open" errors, or a unit that won't start
• Commonly damaged by slamming or misalignment; restores proper latching

• Disconnect power before servicing; also shut off the gas supply if working on a gas dryer
• Open the door, remove fasteners, and note the original strike orientation
• Install the new strike and tighten screws without overtightening
• Close the door to confirm a positive latch; adjust hinge/latch alignment if needed

The Drawer Latch is an OEM part for Frigidaire pedestals. This latch closes storage or pedestal drawers in the base. It creates a tight seal around each drawer, protecting contents from dust and spills.

Issues tend to arise from normal wear over years of use. Drawers opening and closing put stress on latches. Nearby laundry vibrations may also contribute.

Symptoms of a problematic pedestal drawer latch include:

• Drawers that do not fully latch or do not stay closed properly
• Gaps that allow debris or moisture to enter the storage compartments
• Loose or misaligned drawers that are difficult to open and close

This Frigidaire OEM replacement part is also compatible with Electrolux, Gibson, Kelvinator, and some Kenmore ranges.

This dampener regulates airflow inside the refrigerator to help steady temperatures between compartments and reduce temperature swings. It replaces a worn or broken air control piece to restore proper circulation and consistent cooling. What it does:

• Controls airflow between fridge compartments to help maintain even temperatures
• Helps reduce warm or cold spots caused by stuck or broken dampeners
• Minimizes rapid temperature changes when doors open and close
• Operates quietly as part of the internal air distribution system

• Disconnect power to the appliance before starting any repair
• Basic hand tools may be required; handle plastic parts carefully to avoid breakage
• Verify correct orientation and secure mounting for proper airflow operation