Search Results

I noticed the floor around the dishwasher was starting to get wet and warp the wooden floor. The chopper had gotten out of line and had cut a pinhole into the sump housing and the dishwasher was leaking badly. It was quite easy to repair. Just unhook the drain hose and the wire connectors, twist off the turbidity sensor and waste motor, pull out the shims and the whole assemple comes up and out. The hardest part was pulling the motor off of the assembly, since I wasn't sure if I needed to... Read more

Checked the grinder/pump well at the bottom of the dishwasher and fished out some aluminum foil, wire twist ties, broken plastic forks, etc. That was fun but it didn't solve the problem. Purchased new pump & motor assembly and installed it as per Youtube video. It requires pulling out the dishwasher, disconnecting electric, hotwater, and drain lines, and then removing a bunch of clips and connectors. That was time consuming but basically easy ... except that seating the new assembly gasket... Read more

Replaced nut and then found we needed new pump. Read more

I suspected the 'circulation pump' to be the culprit. I could not find a 'circulation pump' so I deduced via the picture schematics it must be the 'casing assembly, pump' I found on the website. I have heard there have been issues with the 'drain pump' so I also ordered the 'case assembly' on this site which is an odd name for the drain pump. Boxes came with just the part inside no instructions or other info. This was fine as I have been diy repairing things my entire life. I made sure... Read more

Replaced the sump housing. Very easy to do once you remove unit from cabinet. Read more

The replacement drain pump was a little labor intensive, but worth it due to the cost of the part. Read more

I drained the dishwasher by hand, disconnected power, water, and drain under the sink. I removed the screws holding the dishwasher in place. I located the pump with the online owners manual and removed it leaving the power connected. I put the machine on the rinse cycle and then hit cancel, the pump is supposed to come on, it didn't, I tried it twice, each time it would start if I manually started it spinning. So I ordered a new drain pump and reversed the removal procedure. Everything worked... Read more

Replaced pump. Has worked for 4+ loads with no further issue. Read more

• Noisy
• Will not drain

Well, I odered the drain pump kit, thinking the impeller was surely trashed. Video made it look easy, so I thought I'd just find the little filter compartment plugged! Hopes dashed, I have the small washer and it has neither the quick remove filter, nor front-side access. After some searching I found the maintenance manual which says to tip the washer forward and get at the pump from below. This compounds my misery because of my installation. It's on a boat, and the dryer's on top, and... Read more

I followed the step by step video. The instructional video was very close to my model. There was good descriptions to most of the issues encountered. The parts were competitively priced as well Read more

Since my Samsung Dishwasher would not drain and had a flashing quick light, I removed the racks and both spray wands. Which allowed me to remove the lower screen assembly. This revealed a worn and broken check valve and broken grinder blade. I cleaned the inside of the dishwasher and removed the unit from under the counter. I removed and cleaned the brake assembly ( large transparent plastic section on left side of the dishwasher). I cleaned this for preventive maintenance by taking the float... Read more

Ordered the replacement pump seal kit from AppliancePartsPros. I watched the online how-to video on their website. The impeller was slightly stuck on the motor shaft due to age but overall was amazed at how easy it was to repair. Thanks AplianePartsPros! Read more