Pump

After having intermittent issues with Error Code 01 on our Electrolux dishwasher for several years - the dishwasher started having the code on a more frequent basis. In addition, it did not seem to be draining correctly, and the pump was not as quiet as when new. Prior to this repair, I pulled out the dishwasher, cleaned the hoses and internal parts, ensured hoses were clamped correctly, etc. Researching past repairs posted online, I noted issues with many components - to the point... Read more

At first, I felt there was a problem with the drain hose. Possibly water would not completely drain out due to a poor routing of the drain hose. It seemed fine - I ensured that I had a 32-ince rise and then a good down hill route to the drain. My drain hose does not drain into the garbage disposal. Then I ran a series of manual relay checks for each component. I had replaced the level sensor sometime in the past; so, I figured that was functioning properly. Why would the rinse cycle seem... Read more

I called AppliancePartsPros, talked to a technician to validate problem, ordered part. I had a great talk with the technician. Told him I have electrical engineering experience, used to fix pinball machines and that the pinballs and home appliances were the same design, i.e. inductor in series with a switch across the hot lines. After that the conversation was like two long lost cousins talking at a family barbeque! Great customer service! Read more

I replace the motor. Got the new motor in. Works Great now! Thanks! Read more

The dishwasher would fill with water, and then was silent (during the time you'd expect to hear it washing. Cancel/draining worked fine too. I assumed it was the pump/motor that had failed. The dishwasher was barely 2 years old. The repair was relatively simple. I removed the racks and spinners from inside the dishwasher. I turned off power to the unit and removed the hoses. I found it easiest to pull the dishwasher out of it's space and flip it on its belly so that I could get to the... Read more

• Will not drain

Ordered a replacement. Had to tip washer toward the back to provide access underneath to the pump. Had some difficulty removing the two hose clamps. Pliers were not the best tool. Had to ensure the drive belt was properly engaged with the pulley of the pump. Read more

1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve. Parts $220 for Dishwasher Estimated Labor $400.00 Labor $0.00 Parts $100.00 for Pullout Faucet Estimated Labor $175.00 Labor $0.00 Read more

I ordered new racks, volute and check ball, and new spray arms. Replacing the volute and check ball were the hardest things to do and they were fairly easy to change. The toughest part for me was finding my T15 torxdriver. After replacing these parts the washer operates much better with much higher pressure than what we were experiencing recently. Read more

Replaced pump and motor. Read more

Replaced this simple part. Its almost like whirlpool knows this motor will fail so they made it easy to replace. 2 screws and it just twists off. This one everyone can fix. Savings $250 if i called repair. $550 if I had to replace! Read more

Ordered pump, popped it in. Hardest part was walking down the stairs Read more