Barbara H. September 08, 2011 for Model Number LTF6000FSO The washer starts to spin andthen acts like it locks up and stops. If I stop the machine and open the door and turn the inside and start it again, it will start spinning untill it gets to that spot or section and stop again. What could this be? (A streched belt maybe)
1 Answer Hi Barbara. Is the washer giving any fault codes? What cycle position does it stop in? In the top or the side inside the machine, there are tech.sheets that will be able for you to put it into a field test mode to pinpoint the area in which the problem exists. Such as the pump or the motor. Is the door latch defective? Is the pump clear? Without loading any soap, Put in 3 or 4 towels and start the machine in reg. wash. Observe to see if the machine has soap in it as you may be over soaping and need to cut back on the soap. If there is too much soap then it wont pump out and eventually shut down. Is the cold water inlet valve/hose clogged? Let us know how to help further. Thank you. Read More...
Nancy June 23, 2011 for Model Number lft6000es1 Washer will not high speed spin at the end of rinse cycle.
1 Answer Hello Nancy. You will need to check and see if the door lock assembly 131763256 is bad. If it is bad, it can cause the problems your having. Hope this helps. Read More...
1 Answer Hello Deb. You will need to remove the back access panel. Then place the belt onto the motor shaft and roll the belt onto the spinner pulley. You will want the groved side of the belt to be down on the pulley. Hope this helps. Read More...