Customer Questions and Answers for Control Board by Frigidaire

Jamie, if you could provide the model number in a new inquiry, this will allow for the most accurate information possible.

Tim, Start at the Control Panel/Console 5304504659 / 5304504659. The ER code indicates an issue with the key pad switches in the console " ER/ER ..... Switch Failure". a failed or erratic circuit could produce intermittent inputs to the control board, causing the LED display lights to produce a false code indication.

Jim, You would test the control board at each connection in which you would be looking for 120 vac output for specific cycles. As for the keypad, there is no way to test this without a key chart which the manufacturer does not put on the tech sheet.

Hello Jerry. Test and see if there is power coming to the control board on the unit. If there is power there, and the board does not work, you will need to replace the control board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hello Tom. Depending on the code, it sounds like the panel or the control board in the unit.

Hello Jeff, Turn off the power supply to the unit and verify the power is off. Turn the water supply off to the unit. Remove the kick panel and the water inlet hose connecting to the water valve. Remove the brass connector adaptor and retain it for use on the new water valve. remove the mounting screw/s used to mount the valve to the units' body. Remove the fill hose from the back of the water valve. Install the brass adaptor connector to the new water valve using Teflon tape on the threads, making sure not to allow any of the Teflon tape to get in the area of water flow. Reinstall the water fill hose the the rear of the water valve. Mount the water valve to the frame and reconnect the water supply line to the valve. Turn the water back on and check for leaks. If none is noted, turn power back on to the unit and start a cycle, watching under the unit for any signs of leaks. If none, reinstall the kick panel and the job is complete.

JMP, You will want to check to make sure that the control panel is not in child lock mode. How to exit would be in owners manual. If this checks ok then you want to check your ribbon harness connection at the control board to make sure that it has a good connection. If the connection is good then it may be a problem with the control board.

Hello David. The code is for Vent will not close. If the vent is closed, then you will need to replace the vent 5304467317, the switch is bad.

Charles, At this point, no you don't need a service/repairman. The "PF' and the " Clean S" are both normal displays. "The CLEAN indicator is energized at the end of all wash cycles with the exception of a Rinse and hold cycle. The clean indicator will remain on until the door is opened. After the door is open, ALL indicators will be extinguished with the exception of the “Rinse aid low” if applicable. The SANITIZE indicator is shown in the front display as an “S” and will be energized at the end of any cycle that the Santi option has been selected. The sanitize criteria must be completed correctly for this indicator to come on. This indicator will be extinguished when the door is opened. The PF = Power failure = The control has experienced drop in power to the processor" That would be normal since you turned the power off to the dishwasher. Unless you forgot to mention something, basically all is OK. Thanks and Good Luck

Hey Howard, we have a 45 day "hassle free" return policy. You can click on our return policy link for further details: http://www.appliancepartspros.com/customerservice/returns.aspx. Thanks!