Kevin October 13, 2012 for Model Number FPHD2481KF Touch the buttons for wash cycle and light comes on. When you hit the start button it will not go to "CL" for close door. Is the problem the touchpad control panel or circuit board? Thanks
1 Answer Hi. CL is "closed door" latch issue. If one of the door latch micro switches are not working correctly then this latch will not send power to the control board. Use a volt/ohm meter part # MA-DM1 to assist you in your diagnostics. It will be advantageous to find the supplied tech sheet inside the cabinet to aid you in the diagnosis. It allows you to put the unit in a diagnostic mode which brings up fault codes and tells you which circuit needs assistance. Make sure the unit is level and all 4-legs are snug on the floor so the unit does not sag under a full load and break the latch. Thank You Read More...
Vince September 12, 2012 for Model Number fgh2433kfo I slipped and fell on the dishwasher door which was open I closed the door and did not realize the screw had come loose. it looks as if it punctured the power on touch control. Will not run a cycle flashes letters and a number but the motor or pump will run when door is closed no water. I am assuming control panel needs replacing also door is has a strong lean to floor is there something i can do to correct that
1 Answer Hello Vince. Replace the control panel and both arms 5304513274 and 5304513274 to correct the lean of the door. Read More...
Jerry May 31, 2012 for Model Number bghd2433kf1 Power went out at house but came back on a second later. This is when we noticed the buttons and power on the dishwasher no longer worked. The are all dead. Checked the obvoius such as curcuit breaker and such. There is power to the dishwasher from the outlet.
1 Answer Hello Jerry. If there is power coming to the control board, and the unit does not work, you will need to replace the control board 5304514670 in the unit. Read More...
Barry M. March 20, 2012 for Model Number FGHD2433KF1 Dishwasher starts ok and runs for a while then stops and code PF shows.. If door is opened and then closed it starts again but sometimes it switches from a different time than what it is set for. For example it will be 55 minutes or less for Quick Clean and then show 99 minutes for the normal cycle even though the display light is still in the Quick Clean mode
1 Answer Hello Barry. Check and make sure there are no loose connections on the unit. If not, and the ribbon cable is clean and dry, you will need to replace the control board 5304514670. Hope this helps. Read More...