Customer Questions and Answers for Main Top by Frigidaire

No glue or adhesives needed. The top is mounted on by screws by way of mounting brackets already adhered to the glass top.

Kathy, if the cooktop glass 318223626 has been damaged, then it would indeed need to be replaced to correct the glass surface. In regards to any updates to this model, the manufacturer does not list any updates at this time. We would not be able to recommend any specific models as an alternative to your current appliance.

Hello Bev, unfortunately, without a model number, we would not be able to check for that part, the main top 318223626 you have listed does not have s/s trim. It can be used either in a cooktop or stovetop.

Hello Riitta, If you pull out the storage drawer, there should be a tag behind there with the model and serial number on it. Thank you.

JeffT, It sounds like the back of the unit is not seated into the burner box properly and would need to pull the unit out and get it positioned properly. As for the foam tape, there is not a foam tape that would normally be on the side of the unit. You could put foam tape part number 12400041 on the sides.

Hello Amy. Yes, as long as the elements were not damaged, you just need the cooktop.

Kirk, It is possible to replace the element by itself, ant not the complete top. But, you should check the burner infinite (control) switch first. The switch has two(2)_ circuits one for the large element and one for the small element. The switch may have a faulty element circuit. that's a more likely issue than a failed burner element.

Elizabeth, the main top 318223626 is the correct manufacturer replacement. Our picture seems to be backwards, I apologize for the confusion. Thank you.

Nick, The production/serial tag for your range should be located on the right side, front oven support leg/frame. You'll need to open the storage drawer, to see it. But, you do have the correct part number 318223626 318223626 for all (2) versions of the model number you did supply. You should be ine with the part nuimber you supplied.

Hello Mark. That is gas here is the electric. The front of the cooktop can be lifted by removing the two screws that secure it to the range chassis. With the cooktop in the raised position the surface heating elements, warmer zone element and their wiring connections are accessible. The top can be held open by using a wood or plastic prop rod approximately 28 inches long. In the photos below a 1” diameter wooden dowel is used. Use caution not to damage the oven insulation blanket when placing the prop rod. 1. Before removing the element be sure to note the locations of the element mounting clips in the support channel slot. The replacement element must be installed in the same position. 2. Carefully remove the wires from the element. Take note of the terminal identifi cation on the element terminal block for each wire connection. 3. Before the element can be removed from the support channel the locking tab on the mounting clip must be closed by squeezing shut with a pair of pliers. After the repair is complete the tab can be re-opened by using an awl or similar instrument. 4. Remove the mounting screw that secures the element support channel to the cooktop. 5. Carefully pull the support channel away from the cooktop far enough to disengage the element mounting clips from the channel. Slide the element out from between the support channel and the cooktop. Reinstall or replace the element by reversing steps 1-5. 6. Once the elements are removed, you can lift off and replace the main top 318223626.