Dj September 25, 2018 for Model Number 79046583500 Some of the push buttons on my control panel aren't working properly. For instance the temp starts at 350 degrees and will go up but not down and the timer button doesn't function at all. The other control buttons are still working fine. So what do I need to replace to get my oven to function above 350 degrees?
Gary December 26, 2016 for Model Number LGEF3033KBB After using oven at 350 For about 1 hr.I noticed that the broil element was on and I couldn't shut it off. Shut oven off and turned it back on but the same thing happened. Then the F10 code started to flash .The book said to shut of power to stove for 5 minutes and then turn it on but nothing changed the broil element turn on again. What is the fault for the F10 code?
1 Answer Gary, This issue would be caused by either a bad sensor which you can test for 1090 ohms. If this checks ok then the control board 5304510064. Read More...
Kelvin S September 02, 2016 for Model Number LGGF3043KFM My overlay is sliding down how can I repair it
1 Answer Kelvin, The best way to fix the overlay would be to get a new overlay 316419353. Once the overlay comes in then you would want to slide the unit out and remove the rear cover. Remove the clock assembly and then remove the old overlay and clean the plastic on the clock then adhere the new overlay to it and reinstall. Read More...
Jane H December 13, 2013 for Model Number 790.46583502 For part AP 3767951 Overlay for Kenmore range, will I need any special tools or need to take parts off range to install new part? Thank you.
1 Answer Jane, The only tools that you should need to replace the overlay is a Phillips head screwdriver and possibly a 1/4" nut driver or socket. You will pull the unit out and remove the rear cover of the control panel. Make sure power is disconnected and take the clock assembly out of the unit. Peel off the old overlay and stick on the new one and reinstall. Read More...
T January 05, 2013 for Model Number LGGF3043KFM Is the overlay just attached with a self adhesive? My controller works fine, it seems as if the overlay is sliding south on the original controller making the clock and where the actual buttons line up hard to use. So I'm thinking of installing a new overlay.