Rocky May 24, 2019 Will this fix my issue with my Frigidaire Model FFSS2314QS1? The freezer gets to cold and the fridge is room temp. Do I need a Temperature sensor or the thermistor assembly?
1 Answer Hello Rocky, you'll want to test the heating element and defrost thermostat both of these parts are located on the evaporator. If both these parts test good you'll want to replace board part number A01078804. Thanks! Read More...
Hoitoto February 08, 2019 for Model Number FFHS2611LWF The frig stays at 44 degree no matter what the temperature setting is 5 to 9. Could it be the thermister? What is the other thing other than the thermister in the thermister assembly?
1 Answer Hoitoto, the thermister reads temperature in ohms of resistance and sends that information to the main control board. The control board turns the cooling on and off based on that resistance reading. Any failure will be in the thermister or in the control board. Read More...
Terry December 09, 2018 for Model Number ffhs2311lwka Damper closes freezer goes to -15 unit will not shut off refrigerator side is warm .
1 Answer Terry, For this issue the most likely cause will be a faulty thermistor keeping the damper closed. If the thermistor checks ok then the damper will be the issue. Read More...
Tim June 05, 2018 for Model Number ffhs2622mwf Can I check to see if my thermistor assembly is good with a continuity tester? If so should the leads show a normally open or normally closed state? I removed mine from the fridge and tried to test it but got no reading.
1 Answer Tim, When testing a thermistor you are looking for a resistance reading and at room temp that reading should be about 5K ohms of resistance. Read More...
Jamie Pancake June 06, 2016 for Model Number FFHS2611LWHA This refrigerator showed a H1 code and everything thawed out. Then it was unplugged and plugged in and started, cooling ok. Then it happened again. Unplugged it and back in and it started again. Could this part be the problem? When it thaws out everything but the lights is off. I ran it through a diagnostic test cycle and every thing checked, even the thermisters. It has been working ok for about 4 days now. The only error code it detected was the e27 the alarm sounding for the high refrigerator temp. When it showed the H1 code and goes off and thaws the alarm does sound each time.
1 Answer Jamie, The H1 that you are seeing if it is in the freezer means that the temp is above 26 degrees, in refrigerator window would mean refrigerator is above 55. With everything being off and unplugging and plugging back up corrects the issue then this would most likely be a control board issue. The part number for the control board is A01078804. Read More...