Bill December 04, 2014 for Model Number 41748102701 I would like to replace water intake valve. How do I disconnect from connection?
1 Answer Hello Bill. Turn off water and remove the hoses. Disconnect the washer from the electrical supply, remove the top panel and cut the 2. Using a small common screw driver, release the (8) locking tabs around the water inlet tubes while pushing on the grommet rim from inside the washer thin wall joint section between the water inlet and the overflow/vent tube grommet. Remove the dispenser and the water valve from the cabinet. Next Remove the valve from the dispenser housing. Install new valve in reverse order. Read More...
Jesus G July 28, 2014 for Model Number ltf2140fs1 One of my cycle setting do not work on my washer that is the quick cycle.
1 Answer Jesus, In most cases when only a certain cycle is not working on a unit then the issue would have to do with a faulty control board. The control board part number is 137005000NH Read More...
1 Answer Hello Jill! Here is the information supplied from the manufacture service manuals, hope it helps! Removing the water inlet grommet: 1. Disconnect the washer from the electrical supply, remove the top panel and cut the 2. Using a small common screw driver, release the (8) locking tabs around the water inlet tubes while pushing on the grommet rim from inside the washerthin wall joint section between the water inlet and the overflow/vent tube grommet . Read More...