Bobby January 01, 2018 for Model Number GSH25JFTABB My fridge is working fine have some water on floor, I just clean the freezer drain pipe and plug back in but both side inside light work but nothing on front display to control. Front display is not light up and compressor does not run. I did turn off my breaker for 30 sec but nothing help
1 Answer Bobby, You will want to test to see if there is 12 vdc to the dispenser control board. If there is then the display board is bad and if not then the main control board will be the issue. Also check to make sure that there is 120 vac at the start relay and if there is not the control board will be the issue. Read More...
Ryan October 12, 2017 for Model Number GSH25JFXBCC Hello my name is Ryan, im looking for this part# in almond or beige AP5955765 Thank you
Phillip September 28, 2017 for Model Number GSH25JSTASS part WR17X11653 I replaced part WR17X11653 and now I have no power to this board. Light bulb is not coming on either. And ice dispenser does nothing. All the lines are connected properly and the fridge is cooling but I have no lights on the control board. Did something break when I was changing the part out? I forgot to unplug the unit. Could I have shorted something when I undid the plugs on the panel? How do I know?
1 Answer Hello Phillip. Based on the information you provided, it sounds like the main board WR55X10942C is bad and will need to be replaced on the unit. Thanks. Read More...
Matt July 07, 2017 for Model Number GSCS3PGXGFSS Purchased home in 2014 with new GE side by side fridge model GSCS3PGXGFSS SERIAL IS LA 403850. It cools fine in the freezer and fridge however, the display where you dispense water and ice is acting weird after a power outage. When you press the lever for ice or water it flashes the temp and does not dispense water or ice. Tried unplugging it and same issue. Also tried resetting the display by setting it off by raising the temp, then hitting cool to reset to factory default, still flashes temp and does not give water or ice.
Luis C March 09, 2017 for Model Number GSL25JFTABS We had a power outage and the control panel stop working. How can I troubleshoot this part to see if indeed the control panel is defective.? The lights are working. its there any reset for this? I just want to order the right part. part# AP5955765
1 Answer Luis, Unfortunately there is really no way to test this control board other than power into the board and power out. If the board will not switch between selections or the dispenser is completely dead of there than the lights being on then this board will likely be the issue with the unit. Read More...
Amanda December 16, 2016 I am trying to hook up a heater to my side by side ge refridgerstor to keep my water line from freezing. The control panel is WR55X10562. On the back of the panel, which 2 wires should I clamp? Power and heater wires? The panel isnt labeled so I dont know which wire to use.
1 Answer Hello Amanda. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Dan May 12, 2016 for Model Number GSH22JSTDSS Recently replaced the motherboard in my ge frigerator as the only thing running was the interior lights. Now i have condenser fan running evap fan running and the front dispenser is flashing 0 for freezer and 0 on fridge setpoint and compressor wont start. Any ideas. should i replace the front dispenser control board?
1 Answer Hello Dan. You will need to read the instruction sheet on the unit and see if the steps were followed properly on replacing the board. Be sure and focus on step number 2 of the instruction sheet. Read More...
Tammi February 04, 2016 for Model Number GSL25JFXBLB Our dispenser has stopped dispensing water. When you press the mechanism, the light comes on and you hear one click, but nothing happens. It still dispenses ice, although most of the time you get crushed ice whether the selection is on crushed or cubed. Which part do we need to fix this?
1 Answer Tammi, You will want to pull the kick plate off the unit and disconnect the tubing at the bottom of the door. Once you do this make sure that the dispenser is set to water. Push the lever and see if water comes from the tube that is coming from under the unit. If it does then the water line in the door is frozen. If the line is frozen then the only correction to this would be to replace the freezer door. Read More...
Michael B. August 16, 2015 for Model Number GSS22JETABB The water works intermittently, but mostly does not work. It only puts out crushed ice no cubed ice. The lights come on for each selection. The door light works. No odd sounds are heard.
1 Answer Hello Michael, You need to pour the ice into a bowl and clean all of the ice particles in the bottom of it at least twice a year, depending on how much it is used. The more it is used, the more often you need to perform this action as per the manufacturer. This allows the mechanism to properly switch from cubed to crushed and back. The water tube in the door is most likely freezing up causing the water dispense issue. This can normally be corrected by installing the water tube heater WR49X10173 in the dispenser. Read More...
Yvette July 29, 2015 for Model Number GSH25JSTASS Compressor is not running, and the temperature face board is not on, but light inside refrigerator works, what could be wrong with it?
1 Answer Hello Yvette. You need to check the main board WR55X10942C and see if it is bad and will need to be replaced on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...