Mike December 12, 2022 for Model Number gdf640hmm0es GE dishwasher 3 yrs old used 30 times it is at my cottage. The control lights are out on the door nothing comes on, I have power to the dishwasher, and the control board down below has power to it, there is a constant little light blinking on the board, I check the round fuse that is plug into the control board and it has continuity, I thinking it is the configured Ui board on the door? What do you think?
1 Answer Mike, You would need to locate the tech sheet provided with the machine and follow the diagnostics. Also, check the door switches as the blinking light could indicate an open door issue. Read More...
Mark December 08, 2022 for Model Number GDF640HSM0SS When is this part expected to be back in stock? Part 903 interface control board.
Tyler March 15, 2022 for Model Number GDF640HGM0WW I ordered and replaced my GE Configured UI Service Control board, power is making it to the control board but nothing is coming on. Checked the main circuit board, it is working and checks good. Any ideas to my problem?
1 Answer Hello Tyler, check the door wire harness that links the boards for internal breaks, these occur at the hinge flex point. If needed the harness is part WD21X22916. Read More...
Ramjet January 31, 2021 for Model Number gdf640hgm0bb My dishwasher has all the lights in the control panel blinking. Will not start, will not reset will do nothing. I have disconnected the power several times, has no effect. Any ideas???
1 Answer Ramjet, if the dishwasher will turn off, the cycle select and the start buttons will need to be pressed and held for 5 seconds to enter into a consumer error mode. Once the LEDs are illuminating (should be a solid light if the door is closed), press and hold the cycle select button for 5 seconds again. This will allow the drain pump WD19X24829, circulation pump WD26X23258, and heating element WD05X35098 to be tested with w proper water level in the tub. Press the cycle select button twice and then press start to allow the dishwasher to fill with water (it will stop automatically). Once 1 minute has passed, press start to turn off the valve test and then press the cycle select once, pressing start here will test the circulation pump test. After 2 minutes, press the start button again and then press the cycle select once more to select the heater and press start. This will test the heater for a maximum of 2 minutes. Once complete, press the cycle select 3 times to select the drain pump and press start. If one of these tests cause the unit to start flashing again, that specific part has failed. If none of them cause the failure again, the issue is in the main control WD21X32165. Read More...