Mark Allen April 13, 2020 for Model Number 2671532110 It is for a stacked gas washer/dryer. I need to get the correct capacitor for the Washer Motor. The motor is WH49X20495. What capacitor should I order and where does it go?
1 Answer Hello Mark. The run capacitor is p/n AP5306339 and it's located behind the washer's front panel on the left side mounted to the frame. Read More...
Luis February 28, 2018 for Model Number GTUP270GM3WW The dryer on my ge washer dryer combo only starts when the start button is held down. It will not run unless the button is kept pressed.
1 Answer Hello Luis. Based on the information you provided, the motor sounds like it is bad and will need to be replaced on the unit. Thank you. Read More...
Brent O. January 05, 2017 for Model Number gtun275em2ww Blocked motor fault came on so we replaced motor. Now blocked motor comes on in spin cycle but wash light blinks in wash cycle. It will try to wash and spin but shuts off right away.
Pat September 21, 2016 for Model Number 363.61532110 I have a washer/dryer combo set first we had the transmission replaced, then we started getting motor errors. So we replaced the motor now the unit will barely agitate...very slow three to four seconds. Between spins ? What could be going on??
1 Answer Pat, This issue would most likely be caused by a faulty fork support assembly which shifts the unit. The part number will be WH16X10147. Read More...
Sam April 18, 2016 Hello, What is the value and part number for the capacitor I can use with the Motor WH49X20495? Thanks
1 Answer Hello Sam. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
John January 10, 2015 for Model Number GTUP270EM0WW Washer going on 5 years old. I am getting a "Blocked Motor" fault code. The washer stops when it is time to spin/agitate on any cycle. Will not start when pressing the "Start" button. Blinking light is either WASH or SPIN. Wash when on a wash cycle. Spin when on a spin cycle. Only stored error code is the Blocked Motor fault. I have cleared code and attempted to start a new cycle. After reviewing a service manaual. I see a "Hall Sensor" listed in the possible trouble list which is rather short for the error code. Where is the Hall Sensor? Can this part be replaced? If not, does this sound like a bad motor? Also: just want to say APP is the best place to go for parts and help!!!
1 Answer John,] The blocked motor fault would most likely be caused by a faulty motor which would need to be replaced. Read More...