Customer Questions and Answers for Orifice Spud Lp 86L by Ge

Jack, The model number listed is not showing as being valid and we will need to have a valid model number to be able to assist with your question. Please resubmit your question with the model number.

James, the left front WB28K10471, left rear WB28K10475 (part has been discontinued by the manufacturer), center WB28K10632 (part has been discontinued by the manufacturer), right rear WB28K10476, and right front WB28K10432 (part has been discontinued by the manufacturer) orifice holders would need to be replaced. Unfortunately, multiple parts have been discontinued by the manufacturer and are no longer available.

Penny, the venturi WB16K10046 would be used with the right front burner. The orifices needs would be part numbers: left-front WB28K10839, center WB28K10288, right-front WB28K10214, left-rear WB28K10215, and right-rear WB28K10031.

Alexis, The part numbers you have provided are for the LP orifices and the only way to get the natural gas orifice will be to get the following parts WB28T10134 left front, WB28T10137 right front, WB28T10125 right rear and WB28T10127 left rear.

It appears that GE only sells the NG orifices with the burner tubes. Here are the part numbers WB28T10134 WB28T10135 WB28T10133 WB28T10125 WB28T10127.

Hello Shelia, the LP orifice (.86) is part WB28K10215.

Michael, the orifice tubes would need to be ordered as the manufacturer does not list the natural gas orifices separately. The part numbers are WB28K10211, WB28K10212, WB28K10210, and WB28K10209. The orifice choke would not be used for NG and the regulator would need to be set to NG. The burner air shutters will need to be adjusted for NG as well.

Kate, The orifices you will need are WB28T10027 the quantity of 2 and they are for the center burner and right rear,WB28T10014 qu. 1 and is for the left rear, WB28T10030 qu 1 and is for the left front, WB28T10027 qu 1 and is for the right front. I will send you an instruction sheet for conversion so you can reverse the procedure. But we will need your correct email address. If you can give us the email and tell us you need a conversion instruct sheet we will get it to you. Please send the model again with your question.

Joshua, to change to natural gas, the following would be needed as the manufacturer does not list the NG orifices separately: LR orifice holder WB28K10475, FL orifice holder WB28K10471, center orifice holder WB28K10472, RR orifice holder WB28K10476, and RF burner assembly WB28K10432. On the oven portion, the orifice hood would need to be loosened 2 1/2 turns to convert to natural gas and the burner shutters would need to be adjusted to the NG setting.

Edward, according to the manufacturers information, you would not need to replace the orifices on the oven section. You will need to adjust the orifice hood using a 1/2" wrench and tighten the orifice hood until it is snug (do not over tighten), and then you will need to adjust the air shutters on the burners to be fully open and adjust as needed.