Customer Questions and Answers for Orifice Spud (Surface Burner) by Ge

Dawn, For the cooktop, you will need the following orifices: WB28X26625 WB28K10834 WB28K10023 WB28K10032 WB28K10215 and then you will convert the pressure regulator back to nat. gas and adjust the oven orifice for Nat. Gas.

Hello Melinda, You will need to order one WB28K10214 for the left front, one WB28K10215 for the left rear, one WB28T10017 for the right front, and two WB28K10031 for the center and right rear.

Li, as the manufacturer does not list the oven NG orifices separately from the connecting parts, the elbow assembly WB28X20389 and the control valve WB21X21506 would be needed.

Bree, the part number [WB28X29964] is still in production. While it does show out of stock, an accurate ETA can be given by calling 1-877-477-7278.

Tim, To get the natural gas orifices on this model you will need to get the orifice holder and tubing Left front WB28K10190, left rear WB28K10188, right rear WB28K10187, and right front WB28K10803.

Hello Bruce. The orifice is the part that lets a small amount of gas come out into the burner. The hole size determines the amount of gas released.

Hello Bill. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx

Mrs V. You will want to tighten the oven orifice 1 1/2 to 2 turns and open the air shutter fully on the burner tube. This should correct the issue.

Mita, We do not have information on weber grills but would say if the unit was set up originally for Natural gas then it would not be convertible to LP but would want to check with the manufacturer for this.

Jimbo, Unfortunately we do not have any information on this grill but it sounds likely that with the N at the end of the model that this unit can only be used on Natural gas.