Barry March 18, 2020 for Model Number DV45h7000EW/A2 My dryer makes a thumping noise when starts up but goes away after a few minutes
1 Answer Barry, it is recommended that the front and rear rollers DC97-16782A are inspected for any flat spots as even a small flat spot can cause this symptom. Read More...
Adam February 28, 2020 for Model Number DV363EWBEUF/A1 The drum roller on the back side closest to the heating panel(right) keeps getting the plastic burned off and/or the blue part as well. i keep replacing it with new parts but this is happening every week. i am currently on week 3 of replacing parts.
1 Answer Hello Adam, the dryer is getting too hot, the possible causes are a restricted exhaust vent, worn drum seals, blower wheel problems reducing airflow, grounded heating element. Read More...
Stephen December 29, 2019 If I bought the Drum Support Roller Assembly, how many rollers do I receive?
Sam August 29, 2019 for Model Number Dv45k6500ev Does the roller assembly require a lubricant? I wiped mine dry trying to assess damage to the shaft D
John Hudson August 26, 2019 for Model Number DV419AEW/XAA-0000 Sounds like a shoe in the dryer all the time now figured it was a roller how do I detect which one. If it is a front one would save time in taring the whole thing down watched that vid on u tube looks not fun.
1 Answer John, You will need to get to the roller giving the issue to confirm that it is it and that there is not more than one. I usually advise replacing all the rollers at the same time so I don't have to tear it down again any time soon due to the sam issue. roller part# DC97-16782A Read More...
Fixinitall June 28, 2019 Our Samsung dryer started to squeak and squeal and we let it go a while before I couldn't take it and ordered the replacement kit. Dryer Repair Kit for Samsung - DC97-16782A Dryer Drum Support Roller) Easy fix. Worked great for 2 weeks. Now its right back to squealing again! I'm about to junk it
1 Answer Hello, you'll want to take a look at the blower wheel as well as the motor as these components could potentially cause a squeak as well. Read More...
Donald April 01, 2019 I am tying to find the bolt that goes through the roller of the roller assembly that turns the drum. It has been worn down and will not allow the roller to turn smoothly....Dryer model DV42H5200EW/A3 I dont see it on the diagrams...
1 Answer Donald, the roller shaft is sold as part of the roller assembly [DC97-16782A]. It comes as the entire assembly due to the damage that is done to a roller from a bad roller shaft. Read More...
Jane B March 26, 2019 for Model Number DV328AEW/XAA Is it recommended that all 4 rollers be replaced if the dryer is noisy? What part of the roller is worn or ruff? Is it in the center bushing area or the outside edge? It doesn't make a big thunderstorm sound but more noisy since I purchased it.
1 Answer Jane, Over time through expansion and contraction the rollers will start causing a noise through the bushing being too tight against the shaft of the roller. Read More...
Nikcolette Jones December 25, 2018 for Model Number DV42H5600EP/A3 My dryer makes a awful loud squealing noise when I turn on , it use to go away after 5 minutes , now its constant. I am planning on replacing a rear roller that is stiff and the idler that looks like its damaged. Do you have any advice what else to do? My dryer is not even 2 yrs old. Thanks
1 Answer Nicolette , The noise that you are describing is usually caused by the idler assembly.DC93-00634A Read More...