Dennis George March 16, 2020 for Model Number Kenmore Washer 110.20992992 Bought in 2001 Agitator is 'lazy.' Can turn in both directions when washer is not in operation. Can only turn clock wise when in operation. Pushing down on agitator when in operation I get a positive and forceful agitation motion. Thinking agitator dogs are worn out, but with a machine this old is it worthwhile to replace entire agitator or maybe the Cam-Kit. ?? This machine has needed zero service since purchased 19 years ago! Thanks
Joe March 08, 2016 for Model Number Kenmore 22902100 Kenmore 90 series top load Model 22902100. I can't access the agitator bolt because the cam is in the way. The center portion shows the top of the bolt but the center portion of the cam blocks it all except the tip of the silver bolt. The piece seems to misaligned, the notches don't match up. Are their alternate ways that bolt comes off? or alternate ways the cam comes out? The bottom appears exactly in the video. I can't access this clutch without getting to the bolt first. I can see the dogs are worn too.
1 Answer Joe, You have a "spring loaded" agitator cam, You will need a 1/2 drive extension to remove the cam assembly and dogs, then you can remove the agitator bolt, and lower agitator, and remove the gearcase to replace the clutch. The agitator Cam Repair Kit for your washer is 285810, sounds like you'll need it, but when you enter the part number into the AppliancePartsPros.com parts order screen, there is a video attached to the part diagram which will show you the procedure. Thanks Read More...
Barb October 13, 2015 for Model Number FWS235RFS6 I cant pull the upper agitator off from bottom...how hard can i pull before i brake something? Thanks!
1 Answer Hello Barb. Once you remove the agitator bolt, it should just lift out of the unit. Read More...
Bernie January 26, 2013 for Model Number 110.22854100 I ordered a kit to replace the upper agitator dog gears and to remove the unit it shows a screw or bolt holding it down. However with mine it looks like a rivit ...there is not a screw or a bolt to try and remove. Any suggestions? My order # is 3109578 Thank you
1 Answer Bernie, Based on the parts diagram and basic service manual, you do have an agitator bolt WP358237 (358237) and the basic instructions state " The surgilator Agitator is removed by first pulling off the agitator cap and inner cap.Then unscrew the 7/16" bolt found under the cap and pull straight up on the two piece agitator assembly. The clutch and clutch dogs that provide the Surgilator action are found in the upper portion of the agitator assembly." Perhaps the bolt is partially coverred with softner or soap residue, or something else. Read More...
1 Answer Hello Rafael. We will need your model number to help you with this. Thanks. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
1 Answer Hello! You can remove the top dispenser/cap 285975. There will be a bolt down in the center of the agitator. You can remove that bolt and the lift up on the agitator. The whole assembly will pull out when that bolt is removed. Hope this helps! Read More...