1 Answer Hello Roger. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Roger January 04, 2016 How do you unplug the power supply for the auger motor? I tried, but can't seem to pull it out of the back wall.
Dt May 21, 2014 for Model Number MSD2756DE When reinstalling the motor on to the back of the ice enclosure, how do you remove the prong (#9 on the part diagram) that goes into the back of the ice tray so that you can feed the motor through the hole in the back of the enclosure?
1 Answer Hello DT. The yoke assembly is reverse threaded and unscrews off the motor shaft. Read More...
Kathleen March 10, 2012 for Model Number MSD2758DRW Please provide me with detailed instructions on how to install this part.
2 Answers Hello Kathleen. First remove the ice crusher bin. Then look at the bottom of the ice enclosure shelf to the right. There is one 1/4 inch hex head screw that holds it in place. Remove this screw and slide up and out and there is a wire harness that must be unplugged. Once the harness is unplugged, the ice enclosure shelf will come out. Replace in reverse order. Be aware, the screw must be reinstalled to keep the ice enclosure shelf in proper position for normal operatio0n. I hope you found this useful. Have a great day! Read More...
Kathleen March 10, 2012 for Model Number MSD2758DRW Please provide me with detailed instructions on how to install this part.
2 Answers Hello Kathleen. First remove the ice crusher bin. Then look at the bottom of the ice enclosure shelf to the right. There is one 1/4 inch hex head screw that holds it in place. Remove this screw and slide up and out and there is a wire harness that must be unplugged. Once the harness is unplugged, the ice enclosure shelf will come out. Replace in reverse order. Be aware, the screw must be reinstalled to keep the ice enclosure shelf in proper position for normal operatio0n. I hope you found this useful. Have a great day! Read More...
Terry August 19, 2011 for Model Number MSD2754GR Motor that turns the rod in the ice tray broke off the plastic. Is part no. AP4070340 what I need. Does not look to difficult either, true..?
1 Answer Hi Terry. Yes, you can remove the Ice bin. Then remove the 1/4" bolt under the lt. side. Then lift and pull the ice enclosure out 1/2 way and unhook the back electrical plug in. Then pull out the rest of the way. Then remove and replace the devices onto the new enclosure. When you hook the new one back up, pre-test the auger motor with the door switch held closed. Thank you. Read More...