Customer Questions and Answers for Field Assembly by Whirlpool

Cesar, as the field assembly WPW10417246 has shorted out, it is very possible that this could have damaged the armature W10900799.

Special Monkey, Based on the information provided there is a short, but you will need to inspect the parts and replace the part and or wire with burned marks or shorted components.

Nic, It may be necessary to tap harder to get the bearing to seat into place.

Tom, based on the information provided, the speed link W11557271, speed lever 9709278, and control plate spring WP3183680 should be inspected to ensure that they are all connected properly. From there, it is possible that there may be a loose wire connection, or if the brushes were removed, that the brushes may have been replaced in an incorrect position. The power cord can be tested for continuity to ensure that one of the wires hadn't broken (black cord is part number W11545825 and the white cord is part number W11396625).

Larry, The armature would be the most likely cause of the vibration but make sure that you check your brushes to make sure that they are not damaged.

Arkady, The first thing to check is to make sure that the carbon brushes are seated in place correctly. If this checks ok then the motor would be the issue with the unit.

Hello David. There should be power on the black wire of the phase control board WPW10325124 of the mixer. Hope this helps.

Hello Larry. Everything in the picture on the part comes with the field assembly W10870869. Hope this helps.