Susan B April 12, 2018 for Model Number KMHC319EBL0 My microwave is not always seeing the door is closed and the error message is OPEN/CLOSE DOOR before I can use it. It looks like the 2 little rollers on the door switch are not springing back all the way when the door is opened. Which switch do I need to replace so that the door "sees" that it is closed?
1 Answer Hello Susan. Grease the cams and test all the door switches to see which one is bad. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Jeremy March 07, 2018 for Model Number MMV1174DS4 How do I get access to replace the fuse in this model? I haven't been able to find a service manual. Thank you.
1 Answer Hello Jeremy. Disconnect the power and remove the outer cover off the microwave to access the fuse in the unit. Thank you. Read More...
D.M.W. January 05, 2018 for Model Number WMH5352OCS-6 Where is the fuse located and how can I access it?
1 Answer Hello D.M.W., First, unplug the unit to prevent electrical shock. You access the fuse on model WMH53520CS6 by removing the two screws on the top edge of the microwave that thread down toward the floor and remove the air grille. You will then remove the single screw above the control board and lift and remove the control panel. The fuse is accessed through this opening. Read More...
Cindy Sanders December 18, 2017 My microwave won't work at all. I know what I did wrong. I turned on the microwave for 35 minutes instead of the timer. I have a maytag MMVA4205BAB. I assume it's the fuse but how do I get to it.
1 Answer Cindy, You will want to pull the unit down from the cabinet and remove the outer panel. This will allow you to access the fuse. Read More...
Julie December 08, 2017 for Model Number Whirlpool microwave GH7208XRB-1 How do I replace the fuse in a built-in Whirlpool microwave? Thank you
1 Answer Hello Julie, As per the service manual: 1. Unplug microwave oven or disconnect power. 2. Open the microwave oven door. 3. Pull the two tabs and remove the center airflow screen from the top of the cabinet. 4. Remove the four indicated screws from the right panel cover, then pull the cover forward, and remove it. 5. Remove the screw from the right panel. To remove the line fuse: a) Unhook the two side tabs, and pull the right panel and relay control board forward as far as the wires will allow. b) Remove the line fuse from the fuse holder. Read More...
Thomas G October 06, 2017 for Model Number UMV1160CB3 The microwave quit working. Where is the fuse located and how do you replace it?
1 Answer Thomas, The fuse can be accessed by removing the control panel of the unit. You will want to remove the air grill at the top of the unit and then remove the single screw holding the control panel in place. The fuse can be accessed from the control panel area. Read More...
Eric June 10, 2017 for Model Number Whirlpool gold microwave model gt4158sks-2 What amperage and volt fuse for this unit?
Jamie April 28, 2017 for Model Number KHHC2090SSS2 Can you tell me what the amp #'s should be on the fuse in this microwave. Should it say 250V/P ? or maybe 125V/20 ?