Russ July 12, 2013 for Model Number NED7200TW Amana dryer doesn't heat and I've done the continuity check on all the parts and replaced the heater element. I'm stuck and need help.
1 Answer Hello Russ. Make sure the voltage is good at the terminal block. If so, then either the motor or timer is not powering the heater. You will need to test them both. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
James S May 16, 2013 for Model Number DV209aew/xaa I need a diagram. where is the heater located, physically?
1 Answer James, To access the heater on unit you will need to remove the main top, control panel and the front panel of the unit. The heater is located on the right side of the base of the unit. Unfortunately we do not have disassembly instructions for Samsung. Read More...
Samantha March 22, 2013 for Model Number amana electric dryer NED7200TW My dryer will not heat up no matter which setting it is on. It stays ice cold. Can you speculate (I know without personal diagnoses you can't be for sure) what could be the issue? Thank you !
1 Answer Hello Samantha. Check and make sure you have 240 volts coming to the dryer. Check and make sure the unit is not set to Air Fluff. Also check the heater and thermostats and see if they are good. You can test these with a multi-meter MA-DM1. They should read closed for continuity. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Gary T November 04, 2012 for Model Number MDE9700AYW I need an electric heating element for this dryer. Your diagram has #24 on the element picture but #24 is a screw listed in the parts list. Thanks
Jj July 01, 2012 for Model Number NED7200TW It just quit heating up today. Is it the heating element?
1 Answer Hello JJ! This answer was located on our Repair Forum, this is a free service in which technicians will assist with answering repair questions for our customers. Please use this link to assist in your repair. Hope this helps you, thanks! http://forum.appliancepartspros.com/dryer-repair/247828-dryer.html Read More...
Jane November 05, 2011 for Model Number NED7200TW10 How do you open the dryer to replace the element?
1 Answer Hi Jane. Remove power. Remove top. remove control panel assy. This will give access to the upper front panel screws. Remove them and bottom screws. Remove the front panel and mark the door switch wires for reinstalling. Once the front panel is removed, the heating element part # WP35001247, is in the rt. front area. If this is bad you will also need to replace the thermal fuse on the front of the heater housing part # WP35001193. All thermostats need to ohm closed. The thermistor at the rt. end of the blower hsg. should read 10,000 ohms at room temperature. It is part # WP35001191. Thank You. Read More...