Mona October 27, 2011 for Model Number ADB1200AWW Hi, I received my replacement door latch, very quicky and exactly what I ordered. Thanks! The only thing is that I didn't notice which wire goes on which side. Does the black wire go on the right, and the white on the left... or is it the other way around?
1 Answer Hello Mona. Looking at the latch assembly W10862259 from the top of the dishwasher, the white is on the right, and the black is on the left. Hope this helps. Read More...
Emily October 11, 2011 My dishwasher is 4 years old and the latch is broken. Is it worth replacing the latch? We are not very handy, is replacing the latch fairly easy and straightforward?
1 Answer Hi Emily. Yes , it is fairly easy. Remove power. Remove the inner door panel. Remove the control assy. bolts. The door latch assy. is bolted to the inside of the control panel. Latch part # is W10862259. Remove, unhook the switch wires noting each wire for proper hook up. Inspect the cont. panel latch mount bosses to see if they are broken. If so you will need to send us exact model # so we can assist with this part # also. This is a good indication that you need to remove the lower kick panel and use a flashlight to see if all 4- legs are down snug as the unit is level front to back, and side to side. This is a main cause why the latches break,(improper installation). Thank you. Read More...
Charles October 07, 2011 for Model Number ADB1200 I just received the door latch woo that was quick.. I was able to get to the latch quickly and I was smart enough to notice the color of the wires Black and white so I was able to put them on the same side of the new one but I did not give it any thought as to how they were plug in is it necessary to get the plug right side up because the prong are the same? I done put it back togeather the door opens much easier now but I turned it on then cancel being satified that it work but it still runs even after canceling to run. Thank you
1 Answer Hello Charles. No, it the wires are on the same switch. White on one and Black on the other switch, the door latch W10862259 should be fine. It should run for about 2 minutes after the cancle is pressed. Hope this helps. Read More...
Charles October 04, 2011 for Model Number adb1200aww In your diagram you have two door latches #3 ap4264083 and #5 ap4264452. which one do I choose and how do I get to the place where I remove the old one to install the new one? I noticed that inside of the door there are 11 screws after that what can I expect to happen?
1 Answer Hello Charles. You will need to order WPW10130695. You will disconnect the power and remove the screws on the inner door panel. Lift the panel up and access the door latch assembly. Remove the wires going to the old latch and install the new latch assembly. Reinstall in reverse order. Hope this helps. Read More...
Davids C. September 26, 2011 for Model Number DDB1501AWB Dishwasher door does not click when door is closed to operate. Door remains unlocked during wash. I have to "clamp" door to washer to keep water in machine. The door handle, which would by used to released/open the door now has no tension. What part is needed to repair door handle?
1 Answer Hi David. You need to replace the door latch part # W10862259. Then make sure you re-level the unit front to back and side to side. Thank you. Read More...
Joseph September 24, 2011 for Model Number Amana Dishwasher? unsure of model I opened the door of my dishwasher and found three numbers not sure which is the model: E39927 LR111720 ADB1500AWW 35949935JR I'm searching for a new latch assembly with handle since mine broke is this the right one for my DW?
1 Answer Hello Joseph! The dishwasher door latch used on your dishwasher is part number WPW10275768. Your model number will be ADB1500AWW and the serial number is 35949935JR. Thanks! Read More...
Cameron June 02, 2011 for Model Number adb2500aww I need a new lach on my amana dishwasher and I think I have found it on your site but I did see that the part was made by whirlpool! Is the part still the correct one for my dishwasher?
1 Answer Hello Cameron. Yes, Whirlpool now owns Maytag and all their brands. WPW10130695 is the door latch with the handle for the model number you provided. Hope this helps. Read More...
Butch May 04, 2011 for Model Number DDB1501AWW How do I get to the latch assembly to replace it? The exploded diagram on your site doesn't show any screws and I can't find any to remove the front panel. Does the whole plastic cover pop off or something like a car door panel?
1 Answer Hello Butch. You will need to open the door and remove the screws on the inside of the door to remove the inner door panel. Once the inner door panel is removed, you can change the door latch assembly out. Hope this helps. Read More...
1 Answer There are no specific step by step instructions on this repair but if you enter your model number on our website you should be able to see a parts break down. Pay attention to how you take it apart and re-assemble in reverse order. Hope this helps. Thanks! Read More...