Jimmy September 09, 2015 for Model Number MGR5751BDS Want to change stove from LP back to nat. Says I need orifice tube assembly left and a right. In the hvac business can I just drill out orifices.
1 Answer Jimmy, You would not be able to drill out the holes to go back to Natural gas as we do not have information on the hole sizes. The parts that you would need would be top left WP5787D105-60, top right WP5787D104-60, bake 12002227, broil 7507P371-60. If you know the size of the holes then yes you could drill them out. Read More...
Denzil May 07, 2013 for Model Number mgr5751bdw My 2 front burners don't work due to the pipes that is attached to the knobs are broken off inside. I tried to lift top of stove while cleaning. What is are parts I need to purchase to repair.
1 Answer Denzil, It sounds like you broke the shafts off of the gas valves 12002281 and the valves would need to be replaced. Read More...
Jason September 14, 2012 for Model Number mgr4452bdw i need to replace the tube assy in my stove and it has been converted to propane is the a diffrence in tube assy
1 Answer Jason, No there is no difference in the tube assemmbly, even for "propane" gas. In your case, you will need to mark and remove the brass burner orifice(s) from the original assembly, and install them in the same location on the new orifice assembly, then install the assembly. Make sure you have power to the range disconnected. Carefully hold your finger over the top of the orifice and turn the gas valve knob to the open position, and check all your connections for a gas leak(with a soap solution) then install the cooktop. Thanks Read More...
Gary V September 05, 2012 for Model Number mgrs752bdw yes i need instructions on removing top to change this part
1 Answer Hello Gary. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Walter May 25, 2012 for Model Number ap4397326 and ap4397327 When these parts are installed will it need any adjustments?
1 Answer Hello Walter. No, you should not need to adjust the orifice tube assembly WP5787D105-60. If the flames do not look right in the unit, you can adjust the orifices. Be sure and leak check the system before lighting it. Read More...
1 Answer Hello! You will need the right hand orifice tube assembly WP5787D104-60 and the left hand orifice tube assembly WP5787D105-60. Thanks! Read More...