Steve October 23, 2012 for Model Number 110.20442990 This Kenmore washer starts to fill with water, and reaches approximately 1/3 full before water starts flowing out of the drain (it may flow earlier, but the water level still rises). It doesn't seem to matter what water level (manual selection via knob) or cycle/water temp is chosen. It spins and pumps fine. We just purchased it used, and I'm wondering if I damaged something while moving it.
1 Answer Steve, The first thing to check is the heigth of the drain pipe. In order to hold the water in the tub properly, the top of the drain pipe must be 38 to 39 inches above the floor level. and make sure the end of the drain hose is not stuffed or sealed to the drain pipe. Read More...
1 Answer Hello Willikam. When you order the kit 285320 it comes with the instruction sheet for you to install the part. Read More...
1 Answer Hello Juan. Check and make sure the unit is draining properly. If not, you will need to check and see if the drain pump W10536347 is bad. If so, it will cause the problems your having, and will need to be replaced. Hope this helps. Read More...
Fred May 12, 2011 for Model Number RAS7133KQ1 My washer will not drain water from tub, washes ok. Would I be onthe right track to assume that the likely fault would be the drain protector? Further what is the purpose of the syphon breaker?
1 Answer Hello Fred. Does the unit spin? If not, you may have a bad lid switch 3949247V. You will need to check and see if the lid switch is bad or broke. The syphon break is used to prevent the machine from syphoning through the drain hose. Hope this helps. Read More...